Highly lubricating and wear‐resistant Ti3C2Tx@SiO2/PI composites based on the action of transfer film at the friction surface
Authors:
- 5 February 2024
- journal article
- research article
- Published by Wiley in Polymer Composites
- Vol. 45 (7) , 6332-6343
Abstract
Polyimide (PI) is a special engineering plastic, widely involved in mechanical components, instruments, and petrochemicals. However, single PI material is inevitably subject to wear and tear in practice, which leads to weakened material properties. In this work, Ti3C2Tx@SiO2 was prepared to enhance the wear resistance and lubrication properties of PI by intercalating SiO2 into the interlayer of Ti3C2Tx sheets. Ti3C2Tx@SiO2/PI composites were fabricated in two steps to test the tribological performances. SiO2 particles change the form of interfacial friction from sliding to rolling, thus relieving direct friction between material and steel ball. So, the composites have a minimum COF (COF = 0.33) when the content of Ti3C2Tx@SiO2 is 0.80 wt%. Moreover, the average value of wear rate was 0.24 × 10−5 mm3/(N·m) when Ti3C2Tx@SiO2 content was 1.60 wt%, which was 91.0% lower compared to the PI matrix. During the friction process, the abrasive chips of the material migrate to the surface of the steel ball to form a transfer film, which protects the material and thus reduces the wear rate. Therefore, the hybrids Ti3C2Tx@SiO2 are effective and important wear‐resistant agents and solid lubricants to improve the wear resistance and lubricity of PI or other polymer materials.Highlights: SiO2 insert Ti3C2Tx is a key factor in changing sliding friction into rolling friction, effectively reducing the COF. The average wear rate was 91.0% lower than that of the polyimide matrix when Ti3C2Tx@SiO2 content was 1.60 wt%. The minimum COF of Ti3C2Tx@SiO2/PI composites reached 0.33 when the content of Ti3C2Tx@SiO2 was 0.80 wt%. The transfer film effectively reduces further wear of the material during friction.Keywords
This publication has 29 references indexed in Scilit:
- Maximizing Terahertz Energy Absorption with MXene AbsorberNano-Micro Letters, 2023
- A new strategy for improvement of interface and mechanical properties of carbon fiber/epoxy composites by grafting graphene oxide onto carbon fiber with hyperbranched polymers via thiol‐ene click chemistryPolymer Composites, 2023
- Effect of homologous molecular crosslinking on the tribological properties of PTFE compositesPolymer Composites, 2023
- Synergistic dispersion and tribo‐film formation of liquid metal @graphene oxide/epoxy coating: Toward improved mechanical and anti‐wear propertiesPolymer Composites, 2023
- Amorphous MXene Opens New PerspectivesAdvanced Materials, 2023
- Improvement in alkali‐resistance of basalt fiber‐reinforced polymer by Ti3C2TX (MXene) modified matrixPolymer Composites, 2023
- Tribological properties of polyimide coating filled with carbon nanotube at elevated temperaturesPolymer Composites, 2020
- Microsphere‐Like SiO2/MXene Hybrid Material Enabling High Performance Anode for Lithium Ion BatteriesSmall, 2019
- Selectively enhanced oil retention of porous polyimide bearing materials by direct chemical modificationJournal of Applied Polymer Science, 2017
- Nitrogen‐Doped Porous Carbon Superstructures Derived from Hierarchical Assembly of Polyimide NanosheetsAdvanced Materials, 2016