SEASAT altimeter height calibration
Authors:
- Ronald KolenkiewiczRKRonald Kolenkiewicz
- Chreston F. MartinCMChreston F. Martin
- 30 April 1982
- journal article
- Published by American Geophysical Union (AGU) in Journal of Geophysical Research: Oceans
- Vol. 87 (C5) , 3189-3197
Abstract
The SEASAT altimeter has been calibrated for height bias using four overflight passes of Bermuda that were supported by the Bermuda laser. The altimeter data was corrected for tides, by using recorded tide gage data; for propagation effects, by using meteorological data taken around the time of each pass; for acceleration lag; and for sea state bias, including both surface effects and instrumental effects. Altimeter data for each of the four passes was smoothed and extrapolated across the island. Interpolation between passes then produced an equivalent altimeter measurement to the geoid at the laser site, so that the altimeter bias could be estimated without the use of a geoid model. The estimated height bias was 0.0±0.07 m.Keywords
This publication has 5 references indexed in Scilit:
- Evaluation of the SEASAT altimeter time tag biasJournal of Geophysical Research: Oceans, 1982
- SEASAT altimeter timing bias estimationJournal of Geophysical Research: Oceans, 1982
- Calibration validation for the GEOS 3 altimeterJournal of Geophysical Research, 1981
- Seasat altimeter sensor file algorithmsIEEE Journal of Oceanic Engineering, 1980
- The reflection of impulses from a nonlinear random seaJournal of Geophysical Research: Oceans, 1979