Prediction of extrudate deposition regimes from rheology and printing kinematics using computational fluid dynamics
Authors:
- 1 December 2025
- journal article
- Published by AIP Publishing in Physics of Fluids
- Vol. 37 (12)
Abstract
The growing adoption of 3D-printing techniques highlights the need for a fundamental understanding of how printing and material parameters influence process efficiency and product quality. This study examines the combined effects of kinematic and rheological parameters on the deposition of soft materials. A virtual tool based on a non-conformal coupling mesh and volume-of-fluid method is developed to capture nozzle motion and emulate the deposition of a single extrudate, assuming Newtonian behavior under isothermal conditions. Extrudate deposition experiments with polylactic acid serve as benchmarks for the simulations. An advanced shape retention index (ASRI) is introduced to quantitatively link printing parameters to extrudate geometry. The roundness of the deposited extrudate varies with viscosity: it either increases or decreases depending on the speed ratio (nozzle flow speed U to nozzle movement speed V) and the normalized gap height (print-bed-to-nozzle distance h relative to nozzle diameter D). The ASRI correlates with the Bond (Bo) and Ohnesorge (Oh) numbers through a power law using either Bo/Oh or Bo2Oh as variables, revealing two deposition regimes: a free state, where h/D is large, and a constrained state, where extrudate height is limited by the nozzle gap. The transition between regimes depends on U/V. The ASRI provides a predictive framework for extrudate shape evolution, capturing the interplay between printing parameters and material flow.Keywords
Funding Information
- Fonds Wetenschappelijk Onderzoek (VS04424N)
- National Natural Science Foundation of China (52311530685)
This publication has 32 references indexed in Scilit:
- Numerical investigation on the viscoelastic polymer flow in material extrusion additive manufacturingAdditive Manufacturing, 2024
- Effect of the ironing process on ABS parts produced by FDMMaterial Design & Processing Communications, 2020
- Motion planning and numerical simulation of material deposition at corners in extrusion additive manufacturingAdditive Manufacturing, 2019
- A printability index for linking slurry rheology to the geometrical attributes of 3D-printed componentsCement and Concrete Composites, 2019
- Experimental validation of a numerical model for the strand shape in material extrusion additive manufacturingAdditive Manufacturing, 2018
- Numerical modeling of the strand deposition flow in extrusion-based additive manufacturingAdditive Manufacturing, 2018
- Conservative interpolation between volume meshes by local Galerkin projectionComputer Methods in Applied Mechanics and Engineering, 2011
- Sliding mesh algorithm for CFD analysis of helicopter rotor–fuselage aerodynamicsInternational Journal for Numerical Methods in Fluids, 2008
- Volume of fluid (VOF) method for the dynamics of free boundariesJournal of Computational Physics, 1981
- A new constitutive equation derived from network theoryJournal of Non-Newtonian Fluid Mechanics, 1977