Effects of shoeing on forelimb biomechanics in walking horses
- 26 April 2026
- journal article
- Published by Wiley in Equine Veterinary Journal
Abstract
Background: Hoof trimming and shoeing techniques are used to manage and prevent equine limb injuries. However, quantitative studies comparing the effects of different shoeing techniques on equine joint biomechanics over the full gait cycle are lacking. Objectives: To measure and compare joint motion and net torques at the distal forelimb joints when horses walk overground unshod, with a standard flat shoe, and with a rocker shoe. Study Design: In vivo study. Methods: Gait data were recorded from 12 sound horses during walking. Three shoeing conditions were tested: unshod, flat shoe, and rocker shoe. Data were recorded for each shoeing condition immediately after trimming (short hoof condition) and again after 6 weeks of hoof growth (long hoof condition). Three‐dimensional motion capture and retro‐reflective skin markers recorded left forelimb motion, while synchronised force plates measured the corresponding ground reaction force. Inverse dynamics was used to calculate the net torques developed about the distal forelimb joints. Statistical comparisons were performed with multilevel mixed effects generalised linear models. Results: While there were limited effects of trimming and shoeing, the rocker shoe was associated with higher walking speed (by 9.3 ± 9.7%) and reduced stride duration (by 4.9 ± 6.9%) compared with the flat shoe for the short hoof condition ( p < 0.001). Throughout the stride cycle, the fetlock joint was less extended (by 9.0 ± 13.7°) while the distal interphalangeal joint (DIPJ) was more extended (by 10.7 ± 16.6°) for both shoeing types compared to unshod regardless of hoof growth ( p < 0.005). Higher peak torques were generated at the DIPJ for flat shoe compared to unshod (by 0.05 ± 0.27 Nm/kg) in the short hoof condition, and for flat shoe compared to rocker shoe (by 0.03 ± 0.14 Nm/kg) in the long hoof condition ( p < 0.05 for both). Main Limitations: The horses were tested at a low‐speed walking gait. Conclusions: Forelimb joint biomechanics did not differ substantially across the three shoeing and two hoof‐growth conditions. Future studies should test the robustness of these findings at the trot and canter.Keywords
Funding Information
- University of Melbourne
This publication has 32 references indexed in Scilit:
- Evaluating the Effect of Routine Hoof Trimming on Fore and Hind Hooves Impact Phase KineticsJournal of Equine Veterinary Science, 2022
- Mechanical Principles of the Equine FootVeterinary Clinics of North America: Equine Practice, 2021
- The Immediate Effect of Routine Hoof Trimming and Shoeing on Horses’ GaitJournal of Equine Veterinary Science, 2021
- Influence of trimming, hoof angle and shoeing on breakover duration in sound horses examined with hoof‐mounted inertial sensorsVeterinary Record, 2021
- The Influence of Different Hind Shoes and Bare Feet on Horse Kinematics at a Walk and Trot on a Soft SurfaceJournal of Equine Veterinary Science, 2018
- Modifying the Height of Horseshoes: Effects of Wedge Shoes, Studs, and Rocker Shoes on the Phalangeal Alignment, Pressure Distribution, and Hoof-Ground Contact During MotionJournal of Equine Veterinary Science, 2017
- Modifying the Surface of Horseshoes: Effects of Eggbar, Heartbar, Open Toe, and Wide Toe Shoes on the Phalangeal Alignment, Pressure Distribution, and the Footing PatternJournal of Equine Veterinary Science, 2016
- Modifying Horseshoes in the Mediolateral Plane: Effects of Side Wedge, Wide Branch, and Unilateral Roller Shoes on the Phalangeal Alignment, Pressure Forces, and the Footing PatternJournal of Equine Veterinary Science, 2016
- The Use of Xylazine or Acepromazine Does Not Interfere in the Lameness Evaluation by Inertial SensorsJournal of Equine Veterinary Science, 2015
- OpenSim: a musculoskeletal modeling and simulation framework for in silico investigations and exchangeProcedia IUTAM, 2011