High efficiency toughness of aromatic sulfonamide in polyamide 6
Authors:
- 17 April 2018
- journal article
- research article
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 135 (30)
Abstract
In order to overcome the brittle fracture characteristics of polyamides, the study on high efficiency toughening of polyamides is always a hot topic. In this article, n‐ethyl‐p‐toluene sulfonamide (N‐PTSA) was used as the toughening agent in polyamide 6 (PA6) matrix. The PA6/N‐PTSA composites were prepared by melt compounding method. The PA6 composites were analyzed systematically from aspects of mechanical properties, thermal properties, crystal structures, and hydrogen bonds. There existed an obvious toughening effect in PA6 composite with the addition of 7 wt % of N‐PTSA. Meanwhile, the tensile strength of the composite was not reduced. The addition of N‐PTSA induced the formation of α‐form crystals, higher crystallinities and lower density of hydrogen bonds in the composites, which was beneficial to improvement of the mechanical properties. Based on the above results, the molecular structure model of toughening mechanism of N‐PTSA in PA6 was established. © 2018 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2018, 135, 46527.Keywords
This publication has 24 references indexed in Scilit:
- On the deformation induced order–disorder transitions in the crystalline phase of polyamide 6European Polymer Journal, 2011
- Crystalline Morphology and Polymorphic Phase Transitions in Electrospun Nylon-6 NanofibersMacromolecules, 2007
- A Model for Toughening of Semicrystalline PolymersMacromolecules, 2007
- Rubber toughening of nylon 6 nanocompositesPolymer, 2006
- Phase morphology and toughening mechanism of polyamide 6/EPDM-g-MA blends obtained via dynamic packing injection moldingPolymer, 2006
- Orientation and structure development in melt-spun Nylon-6 fibresPolymer, 2003
- Investigation of solution-grown, chain-folded lamellar crystals of the even-even nylons: 6 6, 8 6, 8 8, 10 6, 10 8, 10 10, 12 6, 12 8, 12 10, and 12 12Journal of Polymer Science Part B: Polymer Physics, 2000
- Study of the structure development during the melt spinning of nylon 6 fiber by on-line wide-angle synchrotron X-ray scattering techniquesJournal of Polymer Science Part B: Polymer Physics, 1999
- Effects of crystalline forms on the deformation behaviour of nylon-6Polymer, 1998
- Calculation of three-dimensional elastic constants of polymer crystals. 3. α and γ Forms of nylon 6Macromolecules, 1981