FinFET SRAM Optimization With Fin Thickness and Surface Orientation
Authors:
- 30 August 2010
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 57 (11) , 2785-2793
Abstract
In this paper, the design space, including fin thickness (Tfin), fin height (Hfin), fin ratio of bit-cell transistors, and surface orientation, is researched to optimize the stability, leakage current, array dynamic energy, and read/write delay of the FinFET SRAM under layout area constraints. The simulation results, which consider the variations of both Tfin and threshold voltage (Vth), show that most FinFET SRAM configurations achieve a superior read/write noise margin when compared with planar SRAMs. However, when two fins are used as pass gate transistors (PG) in FinFET SRAMs, enormous array dynamic energy is required due to the increased effective gate and drain capacitance. On the other hand, a FinFET SRAM with a one-fin PG in the (110) plane shows a smaller write noise margin than the planar SRAM. Thus, the one-fin PG in the (100) plane is suitable for FinFET SRAM design. The one-fin PG FinFET SRAM with Tfin = 10 nm and Hfin = 40 nm in the (100) plane achieves a three times larger noise margin when compared with the planar SRAM and consumes a 17% smaller bit-line toggling array energy at a cost of a 22% larger word-line toggling energy. It also achieves a 2.3 times smaller read delay and a 30% smaller write delay when compared with the planar SRAM.Keywords
This publication has 18 references indexed in Scilit:
- Impact of Line-Edge Roughness on Double-Gate Schottky-Barrier Field-Effect TransistorsIEEE Transactions on Electron Devices, 2009
- Low-Power and Compact Sequential Circuits With Independent-Gate FinFETsIEEE Transactions on Electron Devices, 2007
- BSIM-MG: A Versatile Multi-Gate FET Model for Mixed-Signal Design2007
- Reducing Variation in Advanced Logic Technologies: Approaches to Process and Design for Manufacturability of Nanoscale CMOS2007
- FinFET SRAM: Optimizing Silicon Fin Thickness and Fin Ratio to Improve Stability at iso Area2007
- Fluctuation limits & amp; scaling opportunities for CMOS SRAM cells2006
- Physically based modeling of low field electron mobility in ultrathin single- and double-gate SOI n-MOSFETsIEEE Transactions on Electron Devices, 2003
- Sensitivity of double-gate and finfet devices to process variationsIEEE Transactions on Electron Devices, 2003
- FinFET scaling to 10 nm gate length2003
- Static-noise margin analysis of MOS SRAM cellsIEEE Journal of Solid-State Circuits, 1987