Finite Element Predictions of Sutured and Coupled Microarterial Anastomoses
Authors:
Open Access
- 1 January 2019
- journal article
- research article
- Published by Japanese Society for Medical and Biological Engineering in Advanced Biomedical Engineering
- Vol. 8, 63-77
Abstract
Simulation using computational methods is well-established for investigating mechanical and haemodynamic properties of blood vessels, however few groups have applied this technology to microvascular anastomoses. This study, for the first time, employs analytic and numeric models of sutured and coupled microarterial anastomoses to evaluate the elastic and failure properties of these techniques in realistic geometries using measured arterial waveforms. Computational geometries were created of pristine microvessels and microarterial anastomoses, performed using sutures and a coupling device. Vessel wall displacement, stress, and strain distributions were predicted for each anastomotic technique using finite element analysis (FEA) software in both static and transient simulations. This study focussed on mechanical properties of the anastomosis immediately after surgery, as failure is most likely in the early post-operative period. Comparisons were also drawn between stress distributions seen in analogous non-compliant simulations. The maximum principal strain in a sutured anastomosis was found to be 84% greater than in a pristine vessel, whereas a mechanically coupled anastomosis reduced arterial strain predictions by approximately 55%. Stress distributions in the sutured anastomoses simulated here differed to those in reported literature. This result is attributed to the use of bonded connections in existing studies, to represent healed surgical sites. This has been confirmed by our study using FEA, and we believe this boundary condition significantly alters the stress distribution, and is less representative of the clinical picture following surgery. We have demonstrated that the inertial effects due to motion of the vessel during pulsatile flow are minimal, since the differences between the transient and static strain calculations range from around 0.6–7% dependent on the geometry. This implies that static structural analyses are likely sufficient to predict anastomotic strains in these simulations. Furthermore, approximations of the shear strain rate (SSR) were calculated and compared to analogous rigid-walled simulations, revealing that wall compliance had little influence on their overall magnitude. It is important to highlight, however, that SSR variations here are taken in isolation, and that changing pressure gradients are likely to produce much greater variation in vessel wall strain values than the influence of fluid flow alone. Hence, a formal fluid-structure interaction (FSI) study would be necessary to ascertain the true relationship.Keywords
This publication has 60 references indexed in Scilit:
- 1000 Consecutive Venous Anastomoses Using the Microvascular Anastomotic Coupler in Breast ReconstructionPlastic and Reconstructive Surgery, 2010
- Mechanical analysis of end‐to‐end silk‐sutured anastomosis for robot‐assisted surgeryThe International Journal of Medical Robotics and Computer Assisted Surgery, 2009
- Microvascular stress analysisBritish Journal of Oral and Maxillofacial Surgery, 2007
- Flow Imaging and Computing: Large Artery HemodynamicsAnnals of Biomedical Engineering, 2005
- Computational modeling of vascular anastomosesBiomechanics and Modeling in Mechanobiology, 2005
- Heritage and early history of the boundary element methodEngineering Analysis with Boundary Elements, 2005
- Numerical study of wall mechanics and fluid dynamics in end-to-side anastomoses and correlation to intimal hyperplasiaJournal of Biomechanics, 1996
- A Numerical Simulation of Flow in a Two-Dimensional End-to-Side Anastomosis ModelJournal of Biomechanical Engineering, 1993
- A numerical method of visco-elastic stress analysisInternational Journal of Mechanical Sciences, 1968
- Handbook of Mathematical Functions With Formulas, Graphs and Mathematical Tables (National Bureau of Standards Applied Mathematics Series No. 55)Journal of Applied Mechanics, 1965