High Capacity Surface-Modified LiCoO2 Cathodes for Lithium-Ion Batteries
Authors:
- A. M. KannanA. M. Kannan
- L. RabenbergLRL. Rabenberg
- A. ManthiramAMA. Manthiram
- 13 November 2002
- journal article
- Published by The Electrochemical Society in Electrochemical and Solid-State Letters
- Vol. 6 (1) , A16-A18
Abstract
The surface of LiCoO 2 cathodes was modified with Al 2 O 3 , TiO 2 , and ZrO 2 by a chemical processing procedure followed by heat treatment at 300°C in air for 4 h. The surface-modified LiCoO 2 samples show much better capacity retention at both 25 and 60°C than the unmodified LiCoO 2 cathode to higher cutoff charge voltages of as high as 4.7 V vs. lithium. For example, Al 2 O 3 -modified LiCoO 2 shows approximately 180 mAh/g at 4.5 to 3.2 V with a capacity fade of only 8% in 100 cycles, compared to 32% for the unmodified LiCoO 2 . Transmission electron microscopic studies reveal that the guest materials are present as loose oxides ( Al 2 O 3 and ZrO 2 ) or as monolayers ( TiO 2 ) on the surface of LiCoO 2 particles. The improved capacity retention and the higher reversible capacity (180 mAh/g) of the surface-modified LiCoO 2 compared to the unmodified LiCoO 2 (140 mAh/g) could be due to a suppression of the chemical and structural instabilities of the charged Li 1 − x CoO 2 cathodes and/or reduction of interparticle stresses and strains. © 2003 The Electrochemical Society. All rights reserved.Keywords
This publication has 15 references indexed in Scilit:
- Phase Relationships and Structural and Chemical Stabilities of Charged Li[sub 1−x]CoO[sub 2−δ] and Li[sub 1−x]Ni[sub 0.85]Co[sub 0.15]O[sub 2−δ] CathodesElectrochemical and Solid-State Letters, 2003
- Comparison of the Chemical Stability of Li1−xCoO2 and Li1−xNi0.85Co0.15O2 CathodesJournal of Solid State Chemistry, 2002
- Issues and challenges facing rechargeable lithium batteriesNature, 2001
- Comparison of the chemical stability of the high energy density cathodes of lithium-ion batteriesElectrochemistry Communications, 2001
- Soft Chemistry Synthesis and Characterization of Layered Li1-xNi1-yCoyO2-δ (0 ≤ x ≤ 1 and 0 ≤ y ≤ 1)Chemistry of Materials, 2001
- Electrochemical Properties of LiCoO[sub 2]-Coated LiMn[sub 2]O[sub 4] Prepared by Solution-Based Chemical ProcessJournal of the Electrochemical Society, 2001
- LiCoO[sub 2] Cathode Material That Does Not Show a Phase Transition from Hexagonal to Monoclinic PhaseJournal of the Electrochemical Society, 2001
- Novel LiCoO2 Cathode Material with Al2O3 Coating for a Li Ion CellChemistry of Materials, 2000
- Improvement of Structural Stability of LiCoO[sub 2] Cathode during Electrochemical Cycling by Sol-Gel Coating of SnO[sub 2]Electrochemical and Solid-State Letters, 1999
- Surface Modification of LiSr[sub 0.002]Ni[sub 0.9]Co[sub 0.1]O[sub 2] by Overcoating with a Magnesium OxideElectrochemical and Solid-State Letters, 1999