An AlN-on-Si resonant IR sensor array with a large temperature coefficient of frequency
- 1 October 2016
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-3
Abstract
This work reports on novel AlN-on-Si flexural-mode resonators with a high fill-factor used as Infrared (IR) sensors. The devices are designed to achieve large temperature coefficient of frequency (TCF) utilizing the thermal expansion coefficient mismatch of different layers in the resonant stack. A 2×2 array of 4.6 MHz resonators with a quality factor (Q) of ~1140 is designed and fabricated using the InvenSense CMOS-MEMS process. Measured TCF values are as high as -137 ppm/K, noticeably higher than the expected TCF derived from temperature coefficient of elasticity (TCE) of AlN and silicon. The reported TCF value in this work is more than four times larger than the previously reported values for AlN-or silicon-based resonators and resonant detectors.Keywords
This publication has 9 references indexed in Scilit:
- A 30 ppm < 80 nJ Ring-Down-Based Readout Circuit for Resonant SensorsIEEE Journal of Solid-State Circuits, 2015
- Un-cooled resonant IR detectors based on Barium Strontium Titanate switchable FBARs2015
- Uncooled Infrared Detectors Using Gallium Nitride on Silicon Micromechanical ResonatorsJournal of Microelectromechanical Systems, 2013
- Aluminum Nitride nano-plate infrared sensor with self-sustained CMOS oscillator for nano-watts range power detection2013
- SENSITIVE UNCOOLED IR DETECTORS USING GALLIUM NITRIDE RESONATORS AND SILICON NITRIDE ABSORBERS2012
- Novel uncooled detector based on gallium nitride micromechanical resonators2012
- Stiffness-compensated temperature-insensitive micromechanical resonators2003
- Mechanically temperature-compensated flexural-mode micromechanical resonators2002
- Low-temperature coefficient bulk acoustic wave composite resonatorsApplied Physics Letters, 1982