Aerodynamics of a Centrifugal Compressor Impeller With Transonic Inlet Conditions
Authors:
Open Access
- 5 June 1995
- conference paper
- Published by ASME International
Abstract
Performance and laser measurement results are presented for a transonic centrifugal compressor stage, equipped with a backswept rotor designed for 586 m/s tip speed and a mean relative inlet tip Mach number of 1.30. The flow field features of the rotor are analysed in detail with the help of laser measurements and the results obtained from a 3D viscous calculation. Both laser measurements and calculations are carried out for the impeller’s design point and a comparison between measured and calculated data is presented for four measurement planes representing the inlet, exit and channel flow conditions. The maximum relative Mach number is found to be 1.45 and a jet/wake type flow exists in the rear part of the flow channel with the wake concentrating in the shroud region. For the operating point investigated, the wake development is due more to the strong shroud curvature in the meridional plane than to a shock induced boundary layer separation. Laser measurements and calculations point to a significant flow displacement in the impeller exit region caused by the wake flow. The theoretical results indicate that a flow separation occurs also at the front side of the vaneless diffuser.Keywords
This publication has 12 references indexed in Scilit:
- An Experimental Investigation of Stator Induced Unsteadiness on Centrifugal Impeller Outflow1994
- Flow Phenomena in a Vaned Diffuser of a Centrifugal Stage1993
- Experimental and Computational Investigation of the NASA Low-Speed Centrifugal Compressor Flow Field1992
- Aerodesign and Performance Analysis of a Radial Transonic Impeller for a 9:1 Pressure Ratio Compressor1992
- The Simulation of Three-Dimensional Viscous Flow in Turbomachinery Geometries Using a Solution-Adaptive Unstructured Mesh Methodology1991
- Secondary Flows and Vortex Motion in a High-Efficiency Backswept Impeller at Design and Off-Design ConditionsJournal of Turbomachinery, 1990
- Verification of an Impeller Design by Laser Measurements and 3D-Viscous Flow Calculations1989
- The Performance of Centrifugal Compressor Channel Diffusers1982
- A Study on Centrifugal Impeller and Diffuser FlowJournal of Engineering for Power, 1981
- Detailed Flow Investigations Within a High-Speed Centrifugal Compressor ImpellerJournal of Fluids Engineering, 1976