Rapid thermal cycling of injection molds: An overview on technical approaches and applications
Authors:
- 1 December 2008
- journal article
- conference paper
- Published by Wiley in Advances in Polymer Technology
- Vol. 27 (4) , 233-255
Abstract
A heated mold with temperature above the polymer‐softening temperature is highly desired in precision injection molding. The elevated mold temperature reduces unwanted freezing during the injection stage, thus improving moldability and enhancing part quality. The resulting advantages include, but are not limited to, longer flow path, improved feature replication and surface transcription, reduced molecular orientations and residual stresses, smoother surfaces of composites, better control of crystallization, stronger weld lines, etc. However, the heated mold needs to be rapidly cooled during the cooling stage to maintain a short cycle time. Despite the large body of available literature, mold rapid heating and cooling does not represent a well‐developed area of practice. Development of capable techniques for rapidly heating and cooling a mold with a relatively large mass is technically challenging because of the constraints set by the heat transfer process and the endurance limits set by the material properties. This article attempts to offer a constructive overview on the state of the art in mold rapid heating and cooling, with the goal of explaining the working mechanisms and providing unbiased accounts of the pros and cons of existing processes and techniques. Successful applications of existing processes are highlighted and potential improvements of these processes are suggested. The article further intends to provide a fundamental understanding of the constituent elements and corresponding building blocks needed in a workable mold with a rapid heating and cooling capability. An increased understanding of these elements will facilitate the development of more capable new processes. © 2009 Wiley Periodicals, Inc. Adv Polym Techn 27:233–255, 2008; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/adv.20136Keywords
This publication has 85 references indexed in Scilit:
- Micro-injection molding with the infrared assisted mold heating systemMaterials Science and Engineering: A, 2007
- Simulation of infrared rapid surface heating for injection moldingInternational Journal of Heat and Mass Transfer, 2006
- Characterization of the Weldline Strength in Terms of Crack Growth Resistance in Injection-Molded Thermoplastic ElastomersPolymer-Plastics Technology and Engineering, 1998
- OPTIMUM DESIGN OF PROCESS CONDITIONS TO MINIMIZE RESIDUAL STRESSES IN INJECTION-MOLDED PARTSJournal of Thermal Stresses, 1998
- Heat transfer in injection moulding systems with insulation layers and heating elementsInternational Journal of Heat and Mass Transfer, 1995
- Experimental Results of Low Thermal Inertia Molding. I. Length of FillingPolymer-Plastics Technology and Engineering, 1988
- Critical J-Integral Value of Injection-Molded Polycarbonate Using a Low Thermal Inertia MoldPolymer-Plastics Technology and Engineering, 1988
- A New Approach to Low Thermal Inertia MoldingPolymer-Plastics Technology and Engineering, 1987
- Low Thermal Inertia Molding (LTIM)Polymer-Plastics Technology and Engineering, 1986
- A finite-element/finite-difference simulation of the injection-molding filling processJournal of Non-Newtonian Fluid Mechanics, 1980