The effect of orientation and pore size on nano mechanical behaviour of Ag thin films: a comparison between experiment and atomistic simulation
- 16 July 2022
- journal article
- research article
- Published by Taylor & Francis in Philosophical Magazine
- Vol. 102 (21) , 2119-2162
Abstract
This paper describes the thickness-dependent texture evolution during annealing in Ag thin films, commonly used in micro and nano-devices. The effect of porosity and crystal orientation on mechanical properties for the films deposited by the magnetron sputtering method is particularly addressed using nano-indentation experiment and atomistic simulation. X-ray pole figure analysis revealed that the films exhibited sharp fibre texture with a major component accompanied by minor twin components of and and a weak component of . The mechanical behaviour of the films was investigated experimentally using a Berkovich tip to measure the hardness (H) and modulus of elasticity (E) at each individual grain and porous region. The average Young’s modulus of strongly oriented [1 1 1] grain at porous and non-porous regions is estimated to be 44 ± 7 and 67 ± 5 GPa. Molecular Dynamics simulations have been performed on (1 1 1), (1 1 0), (0 0 1), (5 1 1), and (5 7 13) surfaces of Ag single crystal using a spherical indenter to investigate the anisotropic nature of hardness and elastic modulus from the Load∼Indentation depth curves. The mechanical properties of [1 1 1] oriented single crystal in the presence of a sub-surface void have been studied. Our results have demonstrated that the void acts as an efficient absorber of dislocation limiting the extension of the plastic zone. The simulated modulus of elasticity (E: 54.2 GPa) results obtained at a temperature of 300 K in the presence of a void are compared with experimentally measured values with a variation of around 6%.Keywords
This publication has 95 references indexed in Scilit:
- Atomic-scale dynamic process of deformation-induced stacking fault tetrahedra in gold nanocrystalsNature Communications, 2013
- Surface science, MEMS and NEMS: Progress and opportunities for surface science research performed on, or by, microdevicesProgress in Surface Science, 2013
- Atomistic simulation of twin boundaries effect on nanoindentation of Ag(111) filmsApplied Surface Science, 2012
- Dislocation density and Burgers vector population in fiber-textured Ni thin films determined by high-resolution X-ray line profile analysisJournal of Applied Crystallography, 2012
- Extracting dislocations and non-dislocation crystal defects from atomistic simulation dataModelling and Simulation in Materials Science and Engineering, 2010
- Mechanical properties of thin Ag films on a silicon substrate studied using the nanoindentation techniquePhysics of the Solid State, 2005
- Dislocation densities, arrangements and character from X-ray diffraction experimentsMaterials Science and Engineering: A, 2001
- Deconvolution of hardness from data obtained from nanoindentation of rough surfacesJournal of Materials Research, 1999
- Determining the mechanical properties of small volumes of material from submicrometer spherical indentationsJournal of Materials Research, 1995
- Effect of macro-porosity on the strength and ductility of cast Al7Si0.3Mg alloyScripta Metallurgica, 1986