Numerical study on breaking solitary wave force on box-girder bridge
Authors:
Open Access
- 13 December 2021
- journal article
- research article
- Published by Springer Nature in Advances in Bridge Engineering
- Vol. 2 (1) , 1-29
Abstract
Solitary wave is often used to simulate tsunami propagating in deep water and breaking solitary wave is often used to simulate tsunami bore propagating in shallow water or on land. The breaking solitary wave force on box-girder, which has been widely used in bridge engineering in coastal areas of China, receives few attentions. This study aims to investigate characteristics and generation mechanism of breaking solitary wave force on box-girder numerically. A numerical wave flume with a 1:20 slope was built firstly, then the solitary wave generation ability, wave deformation and wave breaking on the slope, as well as wave force calculation precision, are validated. The water depth 0.6 m, the slope gradient 1:20 and the distance between slope top and box-girder 2.0 m remain unchanged, while the wave height and clearance changes in different cases. The time histories of horizontal force and vertical force on box-girder can be divided into three and four stages respectively according to their characteristics. The surface of box-girder is decomposed into a series of panels to facilitate exploring tsunami bore force generation mechanism. Results show horizontal force is dominated by static pressure on upstream vertical panels and vertical force is mainly contributed by static pressure on upstream horizontal panels and on panels in the chambers. Tsunami bore overtopping the box-girder deck impacts the top panel vigorously and results in the peak value of negative vertical force.Keywords
This publication has 13 references indexed in Scilit:
- Numerical modeling of non-breaking, impulsive breaking, and broken wave interaction with elevated coastal structures: Laboratory validation and inter-model comparisonsOcean Engineering, 2018
- Component Level–Based Assessment of the Solitary Wave Forces on a Typical Coastal Bridge Deck and the Countermeasure of Air Venting HolesPractice Periodical on Structural Design and Construction, 2016
- Collapse Analysis of Utatsu Ohashi Bridge Damaged by Tohuku Tsunami using Applied Element MethodJournal of Advanced Concrete Technology, 2014
- Experiments and computations of solitary-wave forces on a coastal-bridge deck. Part II: Deck with girdersCoastal Engineering, 2014
- Experiments and computations of solitary-wave forces on a coastal-bridge deck. Part I: Flat PlateCoastal Engineering, 2014
- On the evolution and run-up of breaking solitary waves on a mild sloping beachCoastal Engineering, 2008
- Breaking Criterion and Characteristics for Solitary Waves on SlopesJournal of Waterway, Port, Coastal, and Ocean Engineering, 1997
- Propagation of Long Waves onto ShelfJournal of Waterway, Port, Coastal, and Ocean Engineering, 1992
- Forces on Vertical Wall Caused by Incident BoresJournal of Waterway, Port, Coastal, and Ocean Engineering, 1990
- The Generation of Long Waves in the Laboratory1980