Utilization of Multiple‐Stage Sintering to Control Ni Electrode Continuity in Ultrathin Ni–BaTiO 3 Multilayer Capacitors
- 19 October 2007
- journal article
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 90 (12) , 3811-3817
Abstract
Microstructural control in thin‐layer multilayer ceramic capacitors (MLCCs) is one of the present‐day challenges for maintaining an increase in capacitive volumetric efficiency. The present paper continues a series of investigations aimed at understanding and controlling the microstructural stability of ultrathin Ni electrodes in MLCCs. Here, a kinetic approach based on the control of sintering profiles is used. Ni–BaTiO 3 MLCC chips (0805‐type with 300 active layers) are nonisothermally sintered up to 900°–1300°C with different heating rates in the range from 200° to 3000°C/h. In general, the continuity of the Ni electrodes increases with heating rate. However, a strong nonlinear dependence of Ni electrode continuity on sintering temperature is observed. It is concluded that a low‐melting interfacial liquid (Ni,Ba,Ti) alloy layer initiates at temperatures between 1000° and 1100°C when the Ni electrodes are under tension. This interfacial liquid phase accelerates a stress‐induced diffusion and is the key cause of the severe electrode discontinuities during heating. At higher temperatures (above 1100°C), where compressive stresses are active, the interfacial liquid alloy layer facilitates some recovery of the Ni electrode microstructure. The formation of the interfacial liquid alloy layer can be kinetically controlled using fast‐heating rates, which improves the Ni electrode continuity.Keywords
This publication has 30 references indexed in Scilit:
- Effect of local oxygen activity on Ni–BaTiO3 interfacial reactionsActa Materialia, 2006
- A Novel Approach to Sintering Nanocrystalline Barium Titanate CeramicsJournal of the American Ceramic Society, 2005
- Oxygen nonstoichiometry and dielectric evolution of BaTiO3. Part II—insulation resistance degradation under applied dc biasJournal of Applied Physics, 2004
- Base-Metal Electrode-Multilayer Ceramic Capacitors: Past, Present and Future PerspectivesJapanese Journal of Applied Physics, 2003
- Surface evolution in two-component systemActa Materialia, 2002
- Site Occupancy of Rare-Earth Cations in BaTiO3Japanese Journal of Applied Physics, 2001
- NanosinteringNanostructured Materials, 1999
- Stability of multilayer structures: Capillary effectsNanostructured Materials, 1999
- Effect of Densification Mismatch on Camber Development during Cofiring of Nickel‐Based Multilayer Ceramic CapacitorsJournal of the American Ceramic Society, 1997
- Rapid Rate Sintering of Nanocrystalline ZrO2−3 mol% Y2O3Journal of the American Ceramic Society, 1996