Effect of liquid phase composition on the microstructure and properties of (W,Ti)C cemented carbide cutting tools
- 1 January 2009
- journal article
- Published by Elsevier in International Journal of Refractory Metals and Hard Materials
- Vol. 27 (1) , 83-89
Abstract
No abstract availableKeywords
This publication has 29 references indexed in Scilit:
- Cutting temperature, tool wear, surface roughness and dimensional deviation in turning AISI-4037 steel under cryogenic conditionInternational Journal of Machine Tools and Manufacture, 2007
- Wear behaviour of alumina based ceramic cutting tools on machining steelsTribology International, 2006
- Investigation of heat partition in high speed turning of high strength alloy steelInternational Journal of Machine Tools and Manufacture, 2005
- Growth behavior of rounded (Ti,W)C and faceted WC grains in a Co matrix during liquid phase sinteringActa Materialia, 2005
- Microstructures of binderless tungsten carbides sintered by spark plasma sintering processMaterials Science and Engineering: A, 2003
- Spark plasma sintering behavior of nanocrystalline WC–10Co cemented carbide powdersMaterials Science and Engineering: A, 2003
- Microstructure and mechanical properties of nanocrystalline WC-10Co cemented carbidesScripta Materialia, 2001
- Influence of VC on the microstructure and mechanical properties of WC–Co sintered cemented carbidesInternational Journal of Refractory Metals and Hard Materials, 1999
- A history of fine grained hardmetalInternational Journal of Refractory Metals and Hard Materials, 1995
- A new look at carbide tool lifeWear, 1993