Effect of Intermetallics and Drill Materials on the Machinability of Al-Si Cast Alloys
Open Access
Abstract
The present study was conducted on the machinability of 396 alloy (containing approximately 11% Si) and B319.2 alloy mainly to emphasize the effects of Fe-intermetallics, i.e., α-Fe, β-Fe, and sludge. The results demonstrate that the presence of sludge in the form of hard spots has a significant effect on cutting forces and tool life, in that it decreases drill life by 50% compared to the base alloy. The formation of the α-Fe phase in the M1 base alloy has a beneficial effect on tool life in that this alloy produces the highest number of holes drilled compared to alloys containing sludge or β-Fe; this result may be explained by the fact that the formation of the α-Fe intermetallic, with its rounded Chinese script morphology and its presence within α-Al dendrites, is expected to improve matrix homogeneity via hardening of the soft α-Al dendrites. Increasing the Fe-content from 0.5% to 1% in the 396-T6 alloy containing 0.5% Mn produces a distinct improvement in alloy machinability in terms of cutting force and tool life. The addition of Fe and/or Mn appears to have no discernible effect on the build-up edge area (BUE) and chip shape.Keywords
This publication has 19 references indexed in Scilit:
- Investigating the Machinability of Al–Si–Cu cast alloy containing bismuth and antimony using coated carbide insertMeasurement, 2015
- Effects of Fe intermetallics on the machinability of heat-treated Al–(7–11)% Si alloysJournal of Materials Processing Technology, 2010
- Influence of additives on the microstructure and tensile properties of near-eutectic Al–10.8%Si cast alloyMaterials & Design (1980-2015), 2009
- A study of tensile properties in Al–Si–Cu and Al–Si–Mg alloys: Effect of β-iron intermetallics and porosityMaterials Science and Engineering: A, 2008
- Effect of Si Content on Turning Machinability of Al-Si Binary Alloy CastingsMATERIALS TRANSACTIONS, 2008
- The influence of the microstructure of three Al–Si alloys on the cutting-force amplitude during fine turningInternational Journal of Machine Tools and Manufacture, 2006
- The effect of iron and manganese on the formation of intermetallic compounds in aluminum–silicon alloysMaterials Science and Engineering: A, 2004
- Evolution of the main intermetallic phases in Al-Si-Cu-Mg casting alloys during solution treatmentJournal of Materials Science, 2004
- Iron intermetallic phases in the Al corner of the Al-Si-Fe systemMetallurgical and Materials Transactions A, 2003
- In-process prediction of corner wear in drilling operationsJournal of Materials Processing Technology, 2000