Optimization of lithium vapor box divertor evaporator location on NSTX-U using SOLPS-ITER
Open Access
- 2 July 2024
- journal article
- research article
- Published by IOP Publishing in Nuclear Fusion
- Vol. 64 (8) , 086047
Abstract
Commercial fusion reactors will be faced with extremely high divertor target heat fluxes that will require mitigation. Simulations of detachment in an NSTX-U scenario projected to have 92 MW m−2 unmitigated peak target heat flux are presented, which reaches sub-10 MW m−2 target heat flux using a highly dissipating lithium vapor box divertor design. The lithium vapor box is a detached divertor design which employs lithium vapor evaporation and condensation to contain lithium below the X-point. Previous SOLPS modeling has indicated a lithium vapor box can reduce the heat flux down to 10 MW m−2 via simultaneous evaporation from the Private Flux Region (PFR) and the Common Flux Region (CFR) sides of the vapor box. It is found here that PFR evaporation has improved access to the separatrix leading to significantly more efficient power dissipation than CFR evaporation. Simulations of target evaporation with an evaporation distribution that is self-consistent with the temperature of a Capillary Porous System with Fast flowing liquid lithium could reach n Li / n e ∼ 0.025–0.030 at the Last Closed Flux Surface (LCFS) depending on the liquid metal flow speeds and lithium sputtering yield, while PFR-side evaporation can reach acceptable heat fluxes with n Li / n e ∼ 0.038 at the LCFS. However, PFR evaporator performance can be improved if the target is allowed to be hot enough such that it reflects lithium, reaching n Li / n e ∼ 0.028 and reducing required lithium evaporation. Ultimately PFR evaporation and target evaporation are found to have similar ability to produce acceptable heat flux solutions with minimal upstream concentration.Keywords
Funding Information
- Department of Energy National Nuclear Security Administration Laboratory Residency Graduate Fellowship (DE-AC02-09CH11466)
This publication has 20 references indexed in Scilit:
- The X-Point radiating regime at ASDEX Upgrade and TCVNuclear Materials and Energy, 2023
- Comparing lithium vapor box designs in a high heat flux scenario using SOLPS-ITERNuclear Materials and Energy, 2022
- Predictive modeling of a lithium vapor box divertor in NSTX-U using SOLPS-ITERNuclear Materials and Energy, 2021
- Developments on two lithium vapor-box linear test-stand experimentsNuclear Materials and Energy, 2021
- Modeling of COMPASS tokamak divertor liquid metal experimentsNuclear Materials and Energy, 2020
- Study of lithium vapor flow in a detached divertor using DSMC codeNuclear Materials and Energy, 2019
- Physics design for a lithium vapor box divertor experiment on magnum PSINuclear Materials and Energy, 2019
- Theoretical aspects and practical implications of the heuristic drift SOL modelJournal of Nuclear Materials, 2015
- The new SOLPS-ITER code packageJournal of Nuclear Materials, 2015
- Assessment of DEMO challenges in technology and physicsFusion Engineering and Design, 2013