Effect of bagasse fiber on the flexural properties of biodegradable composites
Authors:
- 21 July 2005
- journal article
- Published by Wiley in Polymer Composites
- Vol. 26 (5) , 689-694
Abstract
Flexural modulus of the press‐molding composites made from bagasse fiber and biodegradable resin was investigated by experiment and numerical prediction with Cox's model that incorporates the compression ratio of the bagasse fiber in the cross section. The effect of the volume fraction of bagasse fiber and its length on the flexural modulus was examined. Up to 65% volume fraction in the experiment, the flexural modulus increased with increase of the volume fraction of the bagasse fiber. The numerical prediction was in good agreement with the experimental result. Above 65% volume fraction, however, the flexural modulus decreased in the experiment, while the prediction increased. It seemed that the biodegradable resin was insufficient to cover all the surface of bagasse fiber in the composite. Moreover, the decrease of the flexural modulus was found below 3 mm at the fiber length in the experimental and the same trend was shown in the numerical prediction. POLYM. COMPOS. 26:689–694, 2005. © 2005 Society of Plastics EngineersKeywords
This publication has 17 references indexed in Scilit:
- The effect of alkalization and fibre alignment on the mechanical and thermal properties of kenaf and hemp bast fibre composites: Part 1 – polyester resin matrixComposites Science and Technology, 2004
- Evaluation of pre-treatment, size and molding pressure on flexural mechanical behavior of chopped bagasse–polyester compositesPolymer Testing, 2004
- Compounding and mechanical properties of biodegradable hemp fibre compositesComposites Science and Technology, 2003
- Kenaf reinforced biodegradable compositeComposites Science and Technology, 2003
- Short jute fiber reinforced polypropylene composites: effect of compatibiliser, impact modifier and fiber loadingComposites Science and Technology, 2003
- A study of fibre and interface parameters affecting the fatigue behaviour of natural fibre compositesComposites Part A: Applied Science and Manufacturing, 2002
- The mechanical properties of vinylester resin matrix composites reinforced with alkali-treated jute fibresComposites Part A: Applied Science and Manufacturing, 2001
- Electromagnetic interference shielding using continuous carbon-fiber carbon-matrix and polymer-matrix compositesComposites Part B: Engineering, 1999
- Influence of natural fibres on the mechanical properties of biodegradable polymersIndustrial Crops and Products, 1998
- Biofiber‐reinforced polypropylene compositesPolymer Engineering & Science, 1997