Phase transformation effect in distortion and residual stress of thin-sheet laser welded Ti-alloy
Authors:
- Bikash KumarBKBikash Kumar
- Swarup BagSBSwarup Bag
- 1 November 2019
- journal article
- research article
- Published by Elsevier in Optics and Lasers in Engineering
- Vol. 122, 209-224
Abstract
No abstract availableKeywords
This publication has 53 references indexed in Scilit:
- Microstructure and mechanical behavior of Ti–6Al–4V produced by rapid-layer manufacturing, for biomedical applicationsJournal of the Mechanical Behavior of Biomedical Materials, 2009
- Electric strain gauge measurement of residual stress in welded panelsThe Journal of Strain Analysis for Engineering Design, 2008
- Prediction of welding distortion and residual stress in a thin plate butt-welded jointComputational Materials Science, 2008
- Finite element simulation of welding and residual stresses in a P91 steel pipe incorporating solid-state phase transformation and post-weld heat treatmentThe Journal of Strain Analysis for Engineering Design, 2008
- Microstructural investigation of friction stir welded pure titaniumMaterials Letters, 2005
- Tensile properties of LBW welds in Ti–6Al–4V alloy at evaluated temperatures below 450 °CMaterials Letters, 2003
- Comparison of keyhole and conventional gas tungsten arc welds in commercially pure titaniumMaterials Science and Engineering: A, 2001
- Electron beam welding, laser beam welding and gas tungsten arc welding of titanium sheetMaterials Science and Engineering: A, 2000
- Determination of dendritic coherency in solidifying melts by rheological measurementsMaterials Science and Engineering: A, 1993
- Transformation Plasticity and Residual Stresses in Single-Pass Repair WeldsJournal of Pressure Vessel Technology, 1992