On the Thermal Stability of ECAP Deformed FCC Metals
Authors:
- 1 October 2007
- journal article
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 558-559, 259-264
Abstract
Pure Cu, CuZr and an Al-alloy were processed by Equal Channel Angular Pressing (ECAP) at room temperature applying route Bc. Microstructure evolution during ECAP and subsequent annealing was investigated. The deformed and annealed states were characterized by EBSD, TEM and microhardness tests. The microstructure variation was recorded and compared to the behavior of conventional cold rolled material. The study revealed a very low thermal stability of ECAP deformed pure Cu samples compared to cold rolled material with same total strain. However, the thermal stability was significantly improved by alloying with Zr. In contrast, ECAP deformed Al-alloy showed higher thermal stability than cold rolled material.Keywords
This publication has 6 references indexed in Scilit:
- Thermal Stability of CP-Aluminium during Annealing after ECAEMaterials Science Forum, 2004
- Evolution of microstructure during annealing of a severely deformed aluminumMaterials Science and Engineering: A, 2004
- EBSP study of the annealing behavior of aluminum deformed by equal channel angular processingMaterials Science and Engineering: A, 2003
- Annealing treatments to enhance thermal and mechanical stability of ultrafine-grained metals produced by severe plastic deformationZeitschrift für Metallkunde, 2003
- Modeling of deformation behavior of copper under equal channel angular pressingZeitschrift für Metallkunde, 2003
- Microstructure of severely deformed Al–3Mg and its evolution during annealingActa Materialia, 2002