Investigation of the surface layer thickness uniformity at the magnetron sputtering depending on the geometry of the flow
Authors:
Open Access
- 7 June 2019
- conference paper
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 525 (1) , 012062
Abstract
The processes of formation of Ti surface layers by magnetron sputtering depending on the geometry of the flow for the subsequent creation of a layered composite are studied. The structure and composition of the resulting layered composite materials were determined using SEM, atomic emission spectrometry and Auger electron spectrometry. The correspondence of morphology of new surfaces and the substrate itself is noted. High adhesion of the components is supposed. The inhomogeneity of the sprayed stream was noted, the main sputtering zone of the target was identified. The gradient of the distribution of the surface layer thickness within the limits of the most intense flux is found, depending on the angle of its incidence on the substrate.Keywords
This publication has 17 references indexed in Scilit:
- Reliability and characteristics of magnetron sputter deposited tantalum nitride for thin film resistorsThin Solid Films, 2018
- Improved mechanical properties, thermal stabilities, and oxidation resistance of arc evaporated Ti-Al-N coatings through alloying with TaSurface and Coatings Technology, 2018
- Biocompatibility of new materials based on nano-structured nitinol with titanium and tantalum composite surface layers: experimental analysis in vitro and in vivoJournal of Materials Science: Materials in Medicine, 2018
- A comparison of electrochemical behavior of coated nanostructured Ta on Ti substrate with pure uncoated Ta in Ringer's physiological solutionJournal of Alloys and Compounds, 2018
- Kinetics of the release of antibiotics from chitosan-based biodegradable biopolymer membranesDoklady Chemistry, 2015
- Mesoporous Fe–alumina films prepared via sol–gel routeMicroporous and Mesoporous Materials, 2015
- Mechanical properties of nanostructured nitinol/chitosan composite materialInorganic Materials: Applied Research, 2014
- Electrochemically deposited chitosan/Ag complex coatings on biomedical NiTi alloy for antibacterial applicationSurface and Coatings Technology, 2013
- Polymer-inorganic nanocomposites based on aromatic polyamidoimides effective in the processes of liquids separationRussian Journal of General Chemistry, 2010
- Surface modification of NiTi alloy with tantalum to improve its biocompatibility and radiopacityJournal of Materials Science, 2006