Effect of Powder Reuse Times on Additive Manufacturing of Ti-6Al-4V by Selective Electron Beam Melting
Top Cited Papers
- 5 February 2015
- journal article
- Published by Springer Nature in JOM
- Vol. 67 (3) , 555-563
Abstract
No abstract availableKeywords
This publication has 8 references indexed in Scilit:
- Manipulation and Characterization of a Novel Titanium Powder Precursor for Additive Manufacturing ApplicationsJOM, 2015
- Characterization of Metal Powders Used for Additive ManufacturingJournal of Research of the National Institute of Standards and Technology, 2014
- Review of effect of oxygen on room temperature ductility of titanium and titanium alloysPowder Metallurgy, 2014
- A transmission electron microscopy and three-dimensional atom probe study of the oxygen-induced fine microstructural features in as-sintered Ti–6Al–4V and their impacts on ductilityActa Materialia, 2014
- Influence of process parameters on the characteristics of TiAl alloyed powders by fluidized bed jet millingPowder Technology, 2014
- Characterization and comparison of materials produced by Electron Beam Melting (EBM) of two different Ti–6Al–4V powder fractionsJournal of Materials Processing Technology, 2013
- Advanced metal powder based manufacturing of complex components by electron beam meltingMaterials Technology, 2009
- Direct metal part forming of 316L stainless steel powder by electron beam selective meltingProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2006