Modeling the Long-Term Deformation of a Geodesic Spherical Frame Structure Made from Wood Plastic Composite Lumber
Open Access
- 21 July 2020
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 10 (14) , 5017
Abstract
The long-term deformation of a geodesic spherical frame structure with a diameter of 20 m made from wood plastic composite (WPC) lumber (struts) is described using the Norton-Bailey power law model to predict the service life creep behavior (the creep strain ( )) of the WPC. The Norton-Bailey power law model parameters, A the power law multiplier, n the stress order, and m the time order, were obtained from experimental four-point bending flexural creep measurements of WPC lumber subjected to three levels of flexural stress: 7, 14, and 29% of the ultimate flexural strength for 200 days. The parameters obtained from the experiments showed good agreement to the model of the WPC lumber in flexure. The Norton-Bailey power law parameters were then implemented to describe the long-term deformation of the spherical frame structure. The limit of failure was considered when the WPC creep strain reaches the value of 1%. However, the FEA predicted the maximum creep strain to be 20% of the failure strain. This modeling approach is considered useful to describe and predict the long-term deformation of aquacultural structures made from viscoelastic materials during the envisioned service life (10 years) based on experimental creep data for the members that form the structure.
Keywords
This publication has 34 references indexed in Scilit:
- Advanced Public Transport Systems, Simulation-Based Evaluation2012
- Water absorption of wood polypropylene composite sheet piles and its influence on mechanical propertiesConstruction and Building Materials, 2011
- Structural Performance of Wood Plastic Composite Sheet PilingJournal of Materials in Civil Engineering, 2010
- Modeling of dynamic behavior of a single-point moored submersible fish cage under currentsAquacultural Engineering, 2010
- Current induced net deformations in full-scale sea-cages for Atlantic salmon (Salmo salar)Aquacultural Engineering, 2008
- Development of structural modeling techniques for evaluating HDPE plastic net pens used in marine aquacultureOcean Engineering, 2007
- Modeling volume deformation in gravity-type cages with distributed bottom weights or a rigid tube-sinkerAquacultural Engineering, 2007
- Numerical simulation of the effects of structure size ratio and mesh type on three-dimensional deformation of the fishing-net gravity cage in currentAquacultural Engineering, 2007
- The design and analysis of a four-cage grid mooring for open ocean aquacultureAquacultural Engineering, 2004
- Fish cage and mooring system dynamics using physical and numerical models with field measurementsAquacultural Engineering, 2003