Microstructural Evolution and Mechanical Performance of Two Joints of Medium-Mn Stainless Steel with Low- and High-Alloyed Steels
Open Access
Abstract
In this work, 2 mm thick medium-Mn austenitic stainless steel (MMn–SS) plates were joined with austenitic NiCr stainless steel (NiCr–SS) and low-carbon steel (LCS) using the gas tungsten arc welding technique. A precise adjustment of the welding process parameters was conducted to achieve high-quality dissimilar joints of MMn–SS with NiCr–SS and LCS. The microstructural evolution was studied using laser scanning confocal and electron microscopes. Secondary electron imaging and electron backscatter diffraction (EBSD) techniques were intensively employed to analyze the fine features of the weld structures. The mechanical properties of the joints were evaluated by uniaxial tensile tests and micro-indentation hardness (HIT). The microstructure of the fusion zone (FZ) in the MMn–SS joints exhibited an austenitic matrix with a small fraction of δ-ferrite, ~6%. The tensile strength (TS) of the MMn–SS/NiCr–SS joint is significantly higher than that of the MMn–SS/LCS joint. For instance, the TSs of MMn–SS joints with NiCr–SS and LCS are 610 and 340 MPa, respectively. The tensile properties of MMn–SS/LCS joints are similar to those of BM LCS, since the deformation behavior and shape of the tensile flow curve for that joint are comparable with the flow curve of LCS. The HIT measurements show that the MMn–SS/NiCr–SS joint is significantly stronger than the MMn–SS/LCS joint since the HIT values are 2.18 and 1.85 GPa, respectively.Keywords
Funding Information
- Business of Finland (5498-31-2021)
This publication has 59 references indexed in Scilit:
- Influence of Carbide Particles on the Grain Growth of Ferrite in an Fe–0.1C–0.09V AlloyISIJ International, 2013
- Dissimilar Welding between AISI 304 Stainless Steel and AISI 1020 Carbon Steel PlatesApplied Mechanics and Materials, 2012
- Is Scanning Electron Microscopy/Energy Dispersive X‐ray Spectrometry (SEM/EDS) Quantitative?Scanning, 2012
- Effect of Cr/Ni equivalent ratio on ductility-dip cracking in AISI 316L weld metalsMaterials & Design (1980-2015), 2011
- Electron backscatter diffraction on pearlite structures in steelJournal of Microscopy, 2006
- Pitting and stress corrosion cracking behavior in welded austenitic stainless steelElectrochimica Acta, 2005
- Effect of welding sequences on residual stressesComputers & Structures, 2003
- Columnar to equiaxed transition in solidification processingScience and Technology of Advanced Materials, 2001
- An improved technique for determining hardness and elastic modulus using load and displacement sensing indentation experimentsJournal of Materials Research, 1992
- The mechanism of sensitization of austenitic stainless steelCorrosion Science, 1990