A real‐time light‐scattering technique for tailings solids measurement
- 9 March 2021
- journal article
- research article
- Published by Wiley in Journal of Environmental Quality
- Vol. 50 (3) , 580-588
Abstract
This study presents the concept of an economic in situ light scattering sensor for real‐time measurement of the solid content in tailings facilities. An experimental setup using a blue (405 nm wavelength) laser diode and silicon photodiodes was constructed to measure the angular distribution of the intensity of scattered light. It was found that the angular intensity of scattered light for tailing samples follow a cosn(θ) relation with n ≈ 1.5 where θ is the angle between the laser beam and the photodiode. An angular value of θ = 20° was chosen for the sensor design based on high signal to noise ratio. The setup was used to determine the relation between scattered light intensity and solids content using a thickened tailings underflow from an oil sands facility and Kaolin as a model material. It was observed that the intensity of scattered light tends to increase with an increase in solids content with qualitatively similar settling behaviour for the two materials but at largely different time scales. An insertion‐based prototype was built and tested in a large (2.7 m height) settling column with treated mature fine tailings, and the light scattering data was verified by standard gravimetric method and gamma ray measurements. In general, good agreement was established between these measurements in absence of optical fouling which demonstrates the potential of the sensor as an effective tool for tailings management. This article is protected by copyright. All rights reservedKeywords
Funding Information
- Natural Sciences and Engineering Research Council of Canada (CRD 507332‐16)
This publication has 13 references indexed in Scilit:
- Coagulation enhanced electrokinetic settling of mature fine oil sands tailingsInternational Journal of Mining Science and Technology, 2019
- Effective sapphire repellency treatment to reduce fouling of a focused beam reflectance measurement (FBRM) probe in bituminous systemsThe Canadian Journal of Chemical Engineering, 2019
- Application of a life cycle assessment to compare environmental performance in coal mine tailings managementJournal of Environmental Management, 2017
- Optical characterization of temperature‐ and composition‐dependent microstructure in asphalt bindersJournal of Microscopy, 2015
- Underwater Superoleophobic Sapphire (0001) SurfacesThe Journal of Physical Chemistry C, 2015
- A review of binders used in cemented paste tailings for underground and surface disposal practicesJournal of Environmental Management, 2013
- Tailings initial consolidation and evaporative drying after deposition2012
- A miniature cell for gas solubility measurements in oils and bitumenReview of Scientific Instruments, 2011
- Freeze-thaw dewatering of oil sands fine tailsCanadian Geotechnical Journal, 1999
- Generalization of Lambert's reflectance model1994