3DAP measurements of Al content in different types of precipitates in aluminium alloys
- 23 January 2007
- journal article
- research article
- Published by Wiley in Surface and Interface Analysis
- Vol. 39 (2-3) , 206-212
Abstract
Three‐dimensional atom probe and field ion microscopy have been used to determine the composition of precipitates formed in several types of aluminium‐based alloys. Special attention has been paid to local magnification artefacts, which are often suspected to strongly disrupt the precipitates' apparent composition. The charge state of Al ions has been used to identify the nature of precipitates (lower or higher evaporation field than the matrix) and also to determine the origin of Al ions observed in 3D reconstructions. The use of a cluster identification method, which allows erosion concentration profiles to be drawn, has revealed the importance of trajectory overlaps in the measurement of the precipitates' composition. By applying this method to low‐evaporation‐field precipitates in a 7XXX alloy, good agreement was found between atom probe measurements and observations in transmission electron microscopy and small angles X‐ray scattering. Copyright © 2007 John Wiley & Sons, Ltd.Keywords
This publication has 23 references indexed in Scilit:
- Comparative study of the β″‐phase in a 6xxx Al alloy by 3DAP and HRTEMSurface and Interface Analysis, 2007
- Coarsening kinetics of nanoscale Al3Sc precipitates in an Al–Mg–Sc alloyActa Materialia, 2005
- Characterisation of the composition and volume fraction of η′ and η precipitates in an Al–Zn–Mg alloy by a combination of atom probe, small-angle X-ray scattering and transmission electron microscopyActa Materialia, 2005
- Early-stage precipitation in Al–Zn–Mg–Cu alloy (7050)Acta Materialia, 2004
- Three dimensional atom probe investigation on the formation of Al3(Sc,Zr)-dispersoids in aluminium alloysScripta Materialia, 2004
- Investigation of fine scale precipitates in Al–Zn–Mg alloys after various heat treatmentsMaterials Science and Engineering: A, 2002
- The chemistry of precipitates in an aged Al-2.1Zn-1.7Mg at.% alloyScripta Materialia, 1999
- Pre-precipitate clusters and precipitation processes in Al–Mg–Si alloysActa Materialia, 1999
- Alloying aluminum alloys with scandium and zirconium additivesMetal Science and Heat Treatment, 1996
- Post-Ionization of Field-Evaporated IonsPhysical Review Letters, 1980