Bulk Current Injection as an Alternative Radiated Susceptibility Test Enforcing a Statistically Quantified Overtesting Margin
- 2 May 2018
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electromagnetic Compatibility
- Vol. 60 (5) , 1270-1278
Abstract
Experimental results are presented in support of the use of bulk current injection (BCI) as an alternative technique to unit-level radiated susceptibility (RS) verifications up to 1 GHz. The rationale for the correlation of BCI/RS test levels is grounded in the concept of overtesting (OT), which quantifies the excess of disturbances injected by BCI with respect to RS. Previous works showed that OT is a random variable, owing to unknown and uncontrolled setup parameters including the common-mode impedance of the equipment under test. The cumulative distribution function (cdf) of OT was shown to be predictable, by means of reasonable statistical assumptions and simple circuit models. This paper fills the gap between that simplified theoretical analysis and the complexity of real-world test setups. To this aim, an ad hoc structure mimicking typical wiring harness and equipment for aerospace applications is tested with BCI and RS to collect several results in terms of power injected/induced in the terminal units. The obtained datasets are processed to infer the empirical cdf of OT. Results are compared with theoretical predictions and properly discussed to point out the correlation between BCI and RS achieved in different test cases (vertical/horizontal antenna polarization, unshielded/shielded cables).Keywords
Funding Information
- European Space Agency (ESA-ESTEC) (4000112761/14/NL/HK)
This publication has 11 references indexed in Scilit:
- A Rationale for Statistical Correlation of Conducted and Radiated Susceptibility Testing in Aerospace EMCIEEE Transactions on Electromagnetic Compatibility, 2017
- Dealing with Uncertainty: A Survey of Theories and PracticesIEEE Transactions on Knowledge and Data Engineering, 2012
- Experimental measurement of the response of a twisted-wire pair exposed to a plane-wave field2011
- Use of Double Bulk Current Injection for Susceptibility Testing of AvionicsIEEE Transactions on Electromagnetic Compatibility, 2008
- Circuit Modeling of Injection Probes for Bulk Current InjectionIEEE Transactions on Electromagnetic Compatibility, 2007
- Feature Selective Validation (FSV) for Validation of Computational Electromagnetics (CEM). Part II— Assessment of FSV PerformanceIEEE Transactions on Electromagnetic Compatibility, 2006
- A Bulk Current Injection Test Conforming to Statistical Properties of Radiation-Induced EffectsIEEE Transactions on Electromagnetic Compatibility, 2004
- Double bulk current injection: a new harness setup to correlate immunity test methods2003
- Currents induced on multiconductor transmission lines by radiation and injectionIEEE Transactions on Electromagnetic Compatibility, 1992
- Comparison measurements of currents induced by radiation and injectionIEEE Transactions on Electromagnetic Compatibility, 1992