Effect of Overheating on the Tensile Properties of Nickel-Based Superalloy GH4720Li
Open Access
Abstract
Aero-engines can be exposed to One Engine Inoperative (OEI) conditions during service, and the resulting overheating effect may significantly impact their structural integrity and flight safety. This paper focuses on the influence of overheating on the microstructural evolution and tensile properties of the GH4720Li alloy, a nickel-based polycrystalline superalloy commonly used in turbine disks. Based on the typical OEI operating conditions of a real aero-engine, a series of non-isothermal high-temperature tensile tests involving an OEI stage of 800 °C were conducted. The effects of OEI-induced overheating on the microstructure and tensile properties of the GH4720Li alloy were investigated. The results showed that, after OEI treatment, the primary γ′ phase in this alloy was partially dissolved. The GH4720Li superalloy also exhibited numerous microcracks at the grain boundaries, resulting in complex effects on its tensile properties. The alloy’s yield strength and ultimate tensile strength were slightly decreased, whereas its ductility decreased considerably. The OEI-induced embrittlement phenomenon was mainly caused by the non-uniform distribution of the tertiary γ′ phase within grains. The formation of microcracks nucleated at the interfaces between the primary γ′ precipitates and γ matrix phase was another key factor.Keywords
Funding Information
- National Natural Science Foundation of China (52122505, Y2019-VIII-0007-0168)
- National Science and Technology Major Project of China (52122505, Y2019-VIII-0007-0168)
This publication has 20 references indexed in Scilit:
- Overheating of Waspaloy: Effect of cooling rate on flow stress behaviorMaterials & Design, 2022
- Effects of Heat Treatment on the Mechanical Behavior of Udimet 720 Nickel-Based SuperalloyJournal of Materials Engineering and Performance, 2022
- The hot deformation behaviors of coarse, fine and mixed grain for Udimet 720Li superalloyMaterials Science and Engineering: A, 2016
- Deformation and recrystallization behavior of a coarse-grain, nickel-base superalloy Udimet720Li ingot materialMaterials Characterization, 2015
- Oxidation assisted intergranular cracking under loading at dynamic strain aging temperatures in Inconel 718 superalloyJournal of Alloys and Compounds, 2015
- Competition between work-hardening effect and dynamic-softening behavior for processing as-cast GH4720Li superalloys with original dendrite microstructure during moderate-speed hot compressionMaterials Science and Engineering: A, 2015
- Strengthening Mechanisms in Polycrystalline Multimodal Nickel-Base SuperalloysMetallurgical and Materials Transactions A, 2009
- Tensile Deformation of a Nickel-base Alloy at Elevated TemperaturesJournal of Materials Engineering and Performance, 2008
- Tensile Properties of Ni-Based Superalloy 720Li: Temperature and Strain Rate EffectsMetallurgical and Materials Transactions A, 2008
- The influence of heat treatment conditions on γ′ characteristics in Udimet® 720Materials Science and Engineering: A, 2004