Unshrouded Plate Fin Heat Sinks for Electronics Cooling: Validation of a Comprehensive Thermal Model and Cost Optimization in Semi-Active Configuration
Open Access
Abstract
Plate Fin Heat Sinks (PFHS) are among the simplest and most widespread devices for electronics cooling. Because of the many design parameters to be considered, developing both cost and thermal effective PFHS is a critical issue. Here, a novel thermal model of PFHS is presented. The model has a broad field of applicability, being comprehensive of the effects of flow bypass, developing boundary layers, fin efficiency and spreading resistance. Experiments are then carried out to validate the proposed thermal model, and its good accuracy is demonstrated. Finally, an optimization methodology based on genetic algorithms is proposed for a cost-effective selection of the design parameters of PFHS, which is particularly effective with semi-active configurations. Such an optimization methodology is then tested on a commercial heat sink, resulting in a possible 53% volume reduction at fixed thermal performances.Keywords
Funding Information
- Ministero dell’Istruzione, dell’Università e della Ricerca (2012LHPSJC)
- Fondazione CRT (NANOSTEP)
This publication has 48 references indexed in Scilit:
- Optimization design of micro-channel heat sink using nanofluid by numerical simulation coupled with genetic algorithmInternational Communications in Heat and Mass Transfer, 2016
- Design, Manufacture and Performance Test of the Thermoelectric Generator System for Waste Heat Recovery of Engine ExhaustInventions, 2016
- Optimal thermal design of a horizontal fin heat sink with a modified-opening model mounted on an LED moduleApplied Thermal Engineering, 2015
- Savings in Cooling Energy with a Thermal Management System for LED Lighting in Office BuildingsEnergies, 2015
- Heat Transfer and Friction Characteristics of the Microfluidic Heat Sink with Variously-Shaped Ribs for Chip CoolingSensors, 2015
- Collector Efficiency in Downward-Type Internal-Recycle Solar Air Heaters with Attached FinsEnergies, 2013
- An assessment on air forced convection on extended surfaces: Experimental results and numerical modelingInternational Journal of Thermal Sciences, 2013
- Thermal Challenges in Next-Generation Electronic SystemsIEEE Transactions on Components and Packaging Technologies, 2008
- The Role of Fin Geometry in Heat Sink PerformanceJournal of Electronic Packaging, 2006
- Single- and two-phase heat exchangers for power electronic componentsInternational Journal of Thermal Sciences, 2000