Measurement of the Degree of Cure of Carbon Fiber Epoxy Composite Materials
Authors:
- 1 September 1996
- journal article
- Published by SAGE Publications in Journal of Composite Materials
- Vol. 30 (13) , 1436-1457
Abstract
In this study, a dielectric cure monitoring system which consists of an electric circuit, a sensor and a personal computer was developed to on-line monitor the dielectric properties of carbon fiber epoxy composite materials. Also, the kinetic model of carbon fiber epoxy composite materials was developed by curve fitting of the differential scanning calorimetry (DSC) data. The start and end points of cure and the relationship between the dissipation factor and the degree of cure were obtained by comparing the dissipation factor from the dielectric properties with the degree of cure from the DSC data. The relationship between the dissipation factor and the degree of cure was tested under various temperature profiles.Keywords
This publication has 8 references indexed in Scilit:
- Modeling the dielectric behavior of epoxy resin blends during curingPolymer Engineering & Science, 1994
- Cure cycle optimization of composites by dielectric measurementsComposites, 1990
- A Fundamental Approach to Resin Cure KineticsJournal of Composite Materials, 1990
- Cure Kinetics and Viscosity of Fiberite 976 ResinJournal of Composite Materials, 1987
- Heat of Reaction, Degree of Cure, and Viscosity of Hercules 3501-6 ResinJournal of Composite Materials, 1982
- Effect of fillers on kinetics of epoxy cureJournal of Applied Polymer Science, 1979
- The use of automatic dielectrometry for autoclave moulding of low void compositesComposites, 1974
- Thermoset characterization for moldability analysisPolymer Engineering & Science, 1974