Formation of voids in composite laminates: Coupled effect of moisture content and processing pressure
Authors:
- 26 February 2014
- journal article
- research article
- Published by Wiley in Polymer Composites
- Vol. 36 (2) , 376-384
Abstract
Void formation as a result of prepreg moisture content and processing pressure during cure was experimentally investigated in thermosetting composite laminates. This was achieved by determining the void contents of eight‐ply laminates fabricated from TenCate® BT250/7781 E‐glass/epoxy prepreg at processing pressures of 1.7, 3.0, 4.4, and 5.8 atm. At each processing pressure, three types of laminates were fabricated using: (i) unconditioned prepregs (direct from the storage bag); (ii) prepregs conditioned at 25% relative humidity; and (iii) 99% relative humidity. Dynamics of prepreg moisture uptake during conditioning was measured using a moisture analyzer and was shown to exhibit Fickian diffusion behavior. The void contents of the cured laminates were found to vary from 1.6% to 5.0% depending on humidity environment the prepregs were exposed and the pressure applied during fabrication. The void contents of all laminates were observed to approach an asymptotic value of ∼1.6% as pressure was increased. The experimental results indicated the processing pressure applied during fabrication was increasingly carried by the fiber bed, reducing resin pressure during cure. Therefore, an enhanced void formation model was proposed through the addition of a pressure reduction factor and an asymptotic void content term. The proposed model was found to accurately predict the void content of laminates made of prepregs exposed to constant/varying humidity environments and fabricated at a wide range of processing pressures. POLYM. COMPOS., 36:376–384, 2015. © 2014 Society of Plastics EngineersKeywords
Funding Information
- Oklahoma EDGE
This publication has 28 references indexed in Scilit:
- Optimization of curing cycle in carbon fiber-reinforced laminates: Void distribution and mechanical propertiesComposites Science and Technology, 2013
- Cure behaviour and void development within rapidly cured out-of-autoclave compositesComposites Part B: Engineering, 2013
- Properties of Composite Cylinders Fabricated by Bladder Assisted Composite ManufacturingJournal of Engineering Materials and Technology, 2012
- Effect of curing cycle on void distribution and interlaminar shear strength in polymer-matrix compositesComposites Science and Technology, 2011
- Void formation in composite prepregs – Effect of dissolved moistureComposites Science and Technology, 2010
- The influence of void content on the structural flexural performance of unidirectional glass fibre reinforced polypropylene compositesComposites Part A: Applied Science and Manufacturing, 2005
- Effect of Injection Rate and Post-Fill Cure Pressure on Properties of Resin Transfer Molded DisksJournal of Composite Materials, 2002
- Flexural and interlaminar shear strength properties of carbon fibre/epoxy composites cured thermally and with microwave radiationComposites Part A: Applied Science and Manufacturing, 2002
- Selection of composite materials and manufacturing routes for cost-effective performanceComposites Part A: Applied Science and Manufacturing, 2002
- Void reduction in autoclave processing of thermoset compositesComposites, 1992