Synthesis and techno-economic assessment of microbial-based processes for terpenes production
Open Access
- 27 October 2018
- journal article
- research article
- Published by Springer Nature in Biotechnology for Biofuels
- Vol. 11 (1) , 1-14
Abstract
Recent advances in metabolic engineering enable the production of chemicals from sugars through microbial bio-conversion. Terpenes have attracted substantial attention due to their relatively high prices and wide applications in different industries. To this end, we synthesize and assess processes for microbial production of terpenes. To explain a counterintuitive experimental phenomenon where terpenes such as limonene (normal boiling point 176 °C) are often found to be 100% present in the vapor phase after bio-conversion (operating at only ~ 30 °C), we first analyze the vapor–liquid equilibrium for systems containing terpenes. Then, we propose alternative production configurations, which are further studied, using limonene as an example, in several case studies. Next, we perform economic assessment of the alternative processes and identify the major cost components. Finally, we extend the assessment to account for different process parameters, terpene products, ways to address terpene toxicity (microbial engineering vs. solvent use), and cellulosic biomass as a feedstock. We identify the key cost drivers to be (1) feed glucose concentration (wt%), (2) product yield (% of maximum theoretical yield) and (3) VVM (Volume of air per Volume of broth liquid per Minute, i.e., aeration rate in min−1). The production of limonene, based on current experimental data, is found to be economically infeasible (production cost ~ 465 $/kg vs. market selling price ~ 7 $/kg), but higher glucose concentration and yield can lower the cost. Among 12 terpenes studied, limonene appears to be the most reasonable short-term target because of its large market size (~ 160 million $/year in the US) and the relatively easier to achieve break-even yield (~ 30%, assuming a 14 wt% feed glucose concentration and 0.1 min−1 VVM). The methods proposed in this work are applicable to a range of terpenes as well as other extracellular insoluble chemicals with density lower than that of water, such as fatty acids. The results provide guidance for future research in metabolic engineering toward terpenes production in terms of setting targets for key design parameters.Keywords
Funding Information
- U.S. Department of Energy (DE-SC0018409)
- National Science Foundation (EFRI-1240268)
This publication has 70 references indexed in Scilit:
- Metabolic engineering of Escherichia coli for limonene and perillyl alcohol productionMetabolic Engineering, 2013
- 2,2-Diphenyl-1-picrylhydrazyl as a screening tool for recombinant monoterpene biosynthesisMicrobial Cell Factories, 2013
- Metabolic Engineering: Past and FutureAnnual Review of Chemical and Biomolecular Engineering, 2013
- Identification and microbial production of a terpene-based advanced biofuelNature Communications, 2011
- Molecular activities, biosynthesis and evolution of triterpenoid saponinsPhytochemistry, 2011
- Production of biofuels and biochemicals: in need of an ORACLETrends in Biotechnology, 2010
- The biomass objective functionCurrent Opinion in Microbiology, 2010
- Increasing diterpene yield with a modular metabolic engineering system in E. coli: comparison of MEV and MEP isoprenoid precursor pathway engineeringApplied Microbiology and Biotechnology, 2009
- Metabolic engineering of microorganisms for isoprenoid productionNatural Product Reports, 2008
- Isolation and screening of d-limonene-resistant microorganismsBrazilian Journal of Microbiology, 2007