Assistance to Determine the Stability State of a Reactive Sputtering Process Based on the Analytical Solution of the Classical Berg Model
Open Access
Abstract
In this study, we propose simple analytical formulas for reactive sputtering technology, which can be used to assist in the selection of appropriate sputtering parameters during the deposition of thin films. Radio frequency (RF) sputtered alumina (Al2O3) was used to evaluate the results. Layers with O/Al ratios ranging from 24/76 to 54/73 were deposited. Following effective deposition, the equations of the Berg model describing the process were studied. The achieved stoichiometry and the associated technological parameters are of critical importance for the analysis of the equations; consequently, this established the primary guiding principle when selecting the analytical approximations. A straightforward graph of the processing parameters (pumping speed, partial pressure) has been constructed, with the objective of avoiding the hysteresis that is an inherent feature of the reactive sputtering process. In addition, we have extended the classical Berg model to examine how the biased substrate can influence deposition. It was found that applying a substrate bias can decrease target coverage, while it does not alter substrate coverage.Keywords
Funding Information
- Ministry of Culture and Innovation of Hungary from the National Research, Development and Innovation Fund (C1792954, K143216)
- Hungarian Scientific Research Fund OTKA (C1792954, K143216)
This publication has 25 references indexed in Scilit:
- The effect of substrate bias on the piezoelectric properties of pulse DC magnetron sputtered AlN thin filmsJournal of Materials Science: Materials in Electronics, 2020
- The critical role of substrate bias for the sputter deposition of molybdenum thin filmsMicroelectronic Engineering, 2019
- A study of the process pressure influence in reactive sputtering aiming at hysteresis eliminationSurface and Coatings Technology, 2013
- Modeling reactive magnetron sputtering: Fixing the parameter setSurface and Coatings Technology, 2012
- Temperature dependence of the sticking coefficient in atomic layer depositionApplied Surface Science, 2010
- Magnetron sputter deposition: Linking discharge voltage with target propertiesThin Solid Films, 2009
- Fundamental understanding and modeling of reactive sputtering processesThin Solid Films, 2005
- Stability analysis of reactive sputtering process with variable sticking coefficientsThin Solid Films, 2005
- Reactive magnetron sputtering of thin films: present status and trendsThin Solid Films, 2005
- Chemical and structural analysis of aluminium-oxygen coatings obtained by d.c. magnetron reactive sputtering: some features of the processSurface and Coatings Technology, 1995