A critical review of Bridgeless PFC boost rectifiers with common-mode voltage mitigation
Authors:
- 1 October 2016
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 3654-3659
Abstract
The paper presented the state-of-the-art Bridgeless Power Factor Correction (BPFC) topologies for mitigating the common-mode (CM) voltage. Based on the CM voltage mitigation performance, the reviewed topologies are classified into four different groups: electrical isolation, semiconductor clamped, passive component clamped and hybrid clamped. The topologies review are provided based on comparing the topologies operation, device selection criteria and the noise of the electromagnetic interference (EMI) generated from the topologies. To analyze the EMI performance of the topology, where high frequency (HF) equivalent circuit models are applied and the corresponding CM noise circuit equation are formulated. A 300W BPFC prototype is used to verify the theoretical analysis by measured the CM voltage and grid current quality in different topologies. The results show that the reviews contents and the analysis models have a good agreement with the experimental findings.Keywords
This publication has 8 references indexed in Scilit:
- Optimal design of a compact 99.3% efficient single-phase PFC rectifier2010
- Common Mode EMI Noise Suppression for Bridgeless PFC ConvertersIEEE Transactions on Power Electronics, 2008
- Balanced switching converter to reduce common-mode conducted noiseIEEE Transactions on Industrial Electronics, 2003
- Comparative analysis of 1-phase active power factor correction topologies2003
- Evaluation of power losses in different CCM mode single-phase boost PFC converters via a simulation tool2002
- High power factor rectifier with reduced conduction and commutation losses1999
- A new ZVS-PWM unity power factor rectifier with reduced conduction lossesIEEE Transactions on Power Electronics, 1995
- Circuit topologies for PWM boost rectifiers operated from 1-phase and 3-phase AC supplies and using either single or split DC rail voltage outputs1995