In Vitro Biomechanical Characteristics of the Spine
Authors:
- Albert J. van der VeenAVAlbert J. van der Veen
- Jaap H. van DieënJaap H. van Dieën
- Idsart KingmaIKIdsart Kingma
- Gijsbertus J. VerkerkeGVGijsbertus J. Verkerke
- Albert G. VeldhuizenAVAlbert G. Veldhuizen
- 1 January 2010
- journal article
- research article
- Published by Wolters Kluwer Health in Spine
- Vol. 35 (2) , E35-E42
Abstract
An in vitro study on human and porcine multilevel spinal segments. To compare human and porcine thoracolumbar spinal segments with respect to their biomechanical characteristics and the effects of creep, recovery, and removal of ligaments and posterior parts on the biomechanical characteristics. Availability of human cadaver spines for in vitro testing of new spinal implants and surgical procedures is limited. Therefore, it is important to search for animal models with representative biomechanical characteristics. A total of 6 human and 6 porcine cadaver spines were dissected in multilevel spinal segments. Pure moments were applied to each segment in flexion/extension, lateral bending, and axial rotation. Creep tests were performed for 30 minutes in 4 creep directions, followed by cyclic tests, a recovery period of 30 minutes, and a series of cyclic tests after removal of ligaments and posterior parts. The range of motion, neutral zone (NZ), and neutral zone stiffness (NZStiff) were calculated from the acquired load-displacement data and results were compared between human and porcine segments. The porcine segments generally had significantly higher absolute values for range of motion and NZ and significantly lower absolute values for NZStiff than the human segments in all directions. The effects of creep and recovery were quite similar in the higher and midthoracic regions of the spine. The influence of removal of ligaments was the same in human and porcine segments. After removal of posterior parts, the lower thoracic porcine spine behaved quite similar to the lumbar human spine. This study showed that the porcine spine can be a good biomechanical model for the human spine in specific situations. The question if the porcine spine can be used to predict the behavior of a human spine depends mainly on the application and the research question.Keywords
This publication has 16 references indexed in Scilit:
- Anatomical measurements of porcine lumbar vertebraeClinical Biomechanics, 2007
- Limitations of the Cervical Porcine Spine in Evaluating Spinal Implants in Comparison With Human Cervical Spinal SegmentsSpine, 2005
- Neutral zone and range of motion in the spine are greater with stepwise loading than with a continuous loading protocol. An in vitro porcine investigationJournal of Biomechanics, 2004
- Comparative Morphometry of L4 VertebraeSpine, 2002
- Are Sheep Spines a Valid Biomechanical Model for Human Spines?Spine, 1997
- Load-displacement properties of the thoracolumbar calf spine: Experimental results and comparison to known human dataEuropean Spine Journal, 1997
- Biomechanical comparison of calf and human spinesJournal of Orthopaedic Research, 1996
- The Effect of Spinal Implant Rigidity on Vertebral Bone Density A Canine ModeSpine, 1991
- Roentgenographic and biomechanical analysis of lumbar fusions: A canine modelJournal of Orthopaedic Research, 1989
- The Biomechanical and Histomorphometric Properties of Anterior Lumbar FusionsJournal of Spinal Disorders, 1988