Characterization of chemical information and morphology for in‐depth oxide layers in decarburized electrical steel with glow discharge sputtering
Authors:
- 10 March 2013
- journal article
- research article
- Published by Wiley in Surface and Interface Analysis
- Vol. 45 (7) , 1119-1128
Abstract
A combination of scanning electron microscopy, X‐ray photoelectron spectroscopy, Fourier transform infrared spectroscopy, and transmission electron microscopy with a sampling method by glow discharge sputtering was successfully employed to characterize the chemical information and microscopic features of oxide layers formed during decarburization annealing of electrical steel in the depth direction at high resolution. The discontinuous surface oxides consisted of SiO 2 , (Fe,Mn)SiO 3 /(Fe,Mn) 2 SiO 4 , and FeO. SiO 2 embedded in the (Fe,Mn) 2 SiO 4 at the surface may be developed by the preferential nucleation and growth kinetics. The discrete or often relatively spherical oxides of internal oxidation by the energetically favorable surface effect were identified as a mixture of SiO 2 and (Fe,Mn) 2 SiO 4 at a depth of ~0.5 µm from the surface. The oxides of networks and small particles at a depth greater than ~1 µm were solely silica, of which the morphologies were possibly caused by the enhanced diffusion of oxygen atoms and Si atoms at grain boundaries or sub‐grain boundaries. The equilibrium and kinetic considerations served by theoretical calculations were introduced to understand the formation and behavior of the observed in‐depth oxidation. Copyright © 2013 John Wiley & Sons, Ltd.Keywords
This publication has 31 references indexed in Scilit:
- Rapid quantitative analysis of fayalite and silica formed during decarburization of electrical steelSurface and Interface Analysis, 2011
- XPS characterization of the oxide scale on fully processed non-oriented electrical steel sheetMaterials Characterization, 2011
- Internal oxidation of Fe–3%Si alloys annealed under H2O–H2 atmosphereMaterials and Corrosion, 2011
- A TEM Study of Oxide Layers Formed during Decarburization Annealing of Electrical SteelISIJ International, 2011
- Effect of heat treatment conditions on the internal and external oxidation processes in non-oriented electrical steelsMaterials & Design (1980-2015), 2005
- X‐ray photoelectron microscopic imaging of the chemical bonding state of Si in a rock sampleSurface and Interface Analysis, 2004
- SIMS/XPS characterization of surface layers formed in 3 mass% Si‐steel by annealing in oxygen at low partial pressureSurface and Interface Analysis, 2003
- A scanning auger microscopy characterization of the internal oxidation produced on carburizingJournal of Heat Treating, 1992
- Study of interfaces in oxidized Fe/Si system by XPS and XAES: Use of the Auger parameterSurface and Interface Analysis, 1986
- Transition from external to internal oxidation in iron-silicon alloy as a function of oxygen potential of the ambient atmosphereScripta Metallurgica, 1976