Investigation on compressibility of Al–SiC composite powders
Authors:
- H. R. HafizpourHHH. R. Hafizpour
- A. SimchiASA. Simchi
- 1 September 2008
- journal article
- Published by SAGE Publications in Powder Metallurgy
- Vol. 51 (3) , 217-223
Abstract
The consolidation behaviour of particulate reinforced metal matrix composite powders during cold uniaxial compaction in a rigid die was studied. Al–SiC powder mixtures with varying SiC particle size, ranging from nanoscale (50 nm) to microscale (40 µm), at different volume fractions up to 30% were used. Based on the experimental results, the effect of the reinforcement particles on the densification mechanisms, i.e. particle rearrangement and plastic deformation, was studied using modified Cooper–Eaton equation. It was found that by increasing the reinforcement volume fraction or decreasing its size, the contribution of particle rearrangement on the densification increases while the plastic deformation becomes restricted. In fact, when percolation network of the ultrafine reinforcement particles is formed, the rearrangement could be the dominant mechanism of consolidation. It was also shown that at tap condition and at the early stage of compaction where the particle rearrangement is dominant, the highest density is achieved when the reinforcement particle size is properly lower than the matrix (0˙3<the size ratio<0˙5) and the fraction of hard particles is relatively low (<10%). At high compaction pressures, the reinforcement particles significantly influence the yield pressure of composite powders, thereby retarding the densification.Keywords
This publication has 23 references indexed in Scilit:
- Study of the compaction behavior of composite powders under monotonic and cyclic loadingComposites Science and Technology, 2005
- Influence of SiC particles oncompressive strength of sintered aluminium alloyPowder Metallurgy, 2003
- Observations on densification of Al-Al 2 O 3 composite powder compacts by pressure cyclingPowder Metallurgy, 2003
- Compaction equations: a comparison of the Heckel and Kawakita equationsPowder Technology, 2002
- Densification behavior of aluminum alloy powder mixed with zirconia powder inclusion under cold compactionMaterials Science and Engineering: A, 2002
- Analysis of compaction behaviour of wet granulated aluminium alloy powderPowder Metallurgy, 2000
- Cold Compaction of Composite PowdersJournal of Engineering Materials and Technology, 1999
- The viscoplastic compaction of composite powdersJournal of the Mechanics and Physics of Solids, 1999
- Relation between percolation and particle coordination in binary powder mixturesActa Metallurgica et Materialia, 1991
- Compaction Behavior of Several Ceramic PowdersJournal of the American Ceramic Society, 1962