Phasor assisted state estimation for NYS transmission system --Implementation & testing
Authors:
- 1 March 2009
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-8
Abstract
This paper describes the implementation, testing, and performance of phasor measurements in an industrial state estimation at the New York Power Authority (NYPA). Phasor Measurement Units (PMU) with GPS synchronization were incorporated into the data acquisition subsystem of the Energy Management System (EMS). The modified state estimator was subjected to pre- and post-field installation testing. The pre-field installation testing was done to verify the correctness of the solution algorithm, to identify the impact of phasor metering accuracy on the quality of estimator solution, to show the relative effectiveness of phasor measurements with respect to other measurements, to identify the effect of the reference bus selection, to detect the impact of PMUs on the state estimator convergence, and to establish the minimum clock synchronization sampling accuracy required for the PMUs. The post-field installation tests were conducted to identify the effectiveness of the PMUs in the state estimator solution using the real-time data as well as to detect the effect of time skewing and measurement weights on the state estimator solution.Keywords
This publication has 13 references indexed in Scilit:
- Optimal Placement of Phasor Measurement Units for Power System ObservabilityIEEE Transactions on Power Systems, 2008
- Effect of Phasor Measurements on the Choice of Reference Bus for State Estimation2007 IEEE Power Engineering Society General Meeting, 2007
- Multiarea State Estimation Using Synchronized Phasor MeasurementsIEEE Transactions on Power Systems, 2005
- Power System State Estimation2004
- Enhancement to Givens rotations for power system state estimationIEEE Transactions on Power Systems, 1991
- Minimization of uncertainties in analog measurements for use in state estimationIEEE Transactions on Power Systems, 1990
- Bad data identification in power system state estimation based on measurement compensation and linear residual calculationIEEE Transactions on Power Systems, 1989
- Real Time Voltage-Phasor Measurement For Static State EstimationIEEE Transactions on Power Apparatus and Systems, 1985
- A New Measurement Technique for Tracking Voltage Phasors, Local System Frequency, and Rate of Change of FrequencyIEEE Transactions on Power Apparatus and Systems, 1983
- State Calculation of Power Systems from Line Flow Measurements, Part IIIEEE Transactions on Power Apparatus and Systems, 1972