Circuit modeling of Surface Acoustic Wave (SAW) resonator with circular geometry
Authors:
- 22 September 2016
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 7, 57-60
Abstract
Surface Acoustic Wave (SAW) devices play an important role in telecommunication systems and are widely used as electronic filters, resonators, actuators and oscillator. SAW resonator consists of metallic structures of interdigitated transducer (IDT) deposited on piezoelectric substrate. The geometry of IDT will affect the resonator's characteristic. There are several methods for modeling and analysing SAW devices include the impulse model, the equivalent circuit model, the coupling-of-mode (COM) model and matrix model. This project focused on the modeling of circular SAW resonator using equivalent circuit technique. Curve fitting between the lumped element circuit and S11 measurement of two resonator designs was demonstrated using AWR Design Environment software. Based on the results, it shows that the frequency response from the equivalent circuit model agrees well with experimental measurement of each device. This project comes out with the optimum equivalent circuit that is suitable for circular SAW resonator.Keywords
This publication has 9 references indexed in Scilit:
- Surface Acoustic Wave Devices and Sensors - A Short Review On Design and Modelling by Impulse ResponseJournal of Environmental Nanotechnology, 2013
- Surface acoustic wave microfluidicsLab on a Chip, 2013
- Theoretical and experimental analysis of high Q SAW resonator transient response in a wireless sensor interrogation application2012
- Optimized Surface Acoustic Wave-based Pressure Sensor Using Equivalent Circuit Model2006
- Evolution of the SAW transducer for communication systems2005
- Acoustic wave technology sensorsIEEE Transactions on Microwave Theory and Techniques, 2001
- Microsystem Design2001
- COUPLING-OF-MODES ANALYSIS OF SAW DEVICESInternational Journal of High Speed Electronics and Systems, 2000
- Review of models for low-loss filter design and applications1994