An Experimental Apparatus for Icing Tests of Low Altitude Hovering Drones
Open Access
Abstract
The icing facilities of the Anti-Icing Materials International Laboratory AMIL have been adapted to reproduce icing conditions on a Bell APT70 drone rotor, typical of small-to-medium UAV models. As part of an extensive icing test campaign, this paper presents the design and preliminary testing of the experimental setup and representative icing conditions calibration in the laboratory’s cold chamber. The drone rotor used has four blades with a diameter of 0.66 m and a maximum tip speed of 208 m/s. For the icing conditions, freezing rain and freezing drizzle were selected. A Liquid Water Content (LWC) calculation methodology for a rotor in hover was developed, and procedures to determine experimental LWC in the facility are presented in this paper. For the test setup, the cold chamber test section was adapted to fit the rotor and to control its ground clearance. Testing was aimed at studying the effect of rotor height h on aerodynamic performance, both with and without icing conditions. Results show no significant effect on the ground effect between h = 2 m and h = 4 m in dry runs, while the icing behavior can be largely influenced for certain conditions by the proximity of the precipitation source, which depend on the height of the rotor in these experiments.Keywords
Funding Information
- Bell Textron Canada Ltd (None)
This publication has 27 references indexed in Scilit:
- An experimental study of surface wettability effects on dynamic ice accretion process over an UAS propeller modelAerospace Science and Technology, 2018
- Numerical Simulations for Ice Accretion on Rotors Using New Three-Dimensional Icing ModelJournal of Aircraft, 2017
- Numerical Simulation and Optimization Analysis of Anti-/De-Icing Component of Helicopter Rotor Based on Big Data Analytics2016
- Piezoelectric Deicing System for RotorcraftJournal of the American Helicopter Society, 2015
- Rotorcraft Aeromechanics2013
- Aircraft Icing Research at NASA Glenn Research CenterJournal of Aerospace Engineering, 2013
- Icing Environment Rotor Test Stand Liquid Water Content Measurement Procedures and Ice Shape CorrelationJournal of the American Helicopter Society, 2012
- Ice accretion simulation on multi-element airfoils using extended Messinger modelHeat and Mass Transfer, 2008
- Experimental Frossling Numbers for Ice-Roughened NACA 0012 AirfoilsJournal of Aircraft, 2003
- On the rise and fall of a ball with linear or quadratic dragAmerican Journal of Physics, 1999