Current-Mode Control of a Coupled-Inductor Buck–Boost DC–DC Switching Converter
- 1 May 2012
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 27 (5) , 2536-2549
Abstract
This paper deepens in the study of the recently described coupled-inductor buck-boost converter. The output voltage of this dc-dc converter can be regulated above and/or below its input voltage with high efficiency and wide bandwidth. The control of the input and/or output nonpulsating converter currents is addressed in this paper. The small-signal control-to-input/output-current transfer functions in open-loop permits the design of the respective average current-mode controllers. The combination of the input- and output-current controllers with an additional output voltage limiter loop is proposed as a method to regulate one of the currents while limiting the maximum values of the other two variables. The theoretical analyses have been validated by means of simulations and also experimentally on a 48-V 800-W purpose built-prototype. In particular, the frequency response measurements that have been carried out for a representative set of the converter operating points are in good agreement with the simulations.Keywords
This publication has 43 references indexed in Scilit:
- A Noninverting Buck–Boost DC–DC Switching Converter With High Efficiency and Wide BandwidthIEEE Transactions on Power Electronics, 2011
- Mathematical analysis of hybrid topologies efficiency for PEM fuel cell power systems designInternational Journal of Electrical Power & Energy Systems, 2010
- Bilevel Current Driving Technique for LEDsIEEE Transactions on Power Electronics, 2009
- A Very Simple Control Strategy for Power Factor Correctors Driving High-Brightness LEDsIEEE Transactions on Power Electronics, 2009
- Optimized topology for high efficiency battery discharge regulatorIEEE Transactions on Aerospace and Electronic Systems, 2008
- PWM conductance control2003
- Modeling average current mode control [of power convertors]2002
- Average current mode control of series-switching post-regulators used in power factor correctorsIEEE Transactions on Power Electronics, 2000
- Optimal single resistors damping of input filters1999
- A general unified approach to modelling switching-converter power stagesInternational Journal of Electronics, 1977