Processing of High Interstitial Austenitic Steel with Powder Bed Fusion‐Laser Beam/Metal: Evolution of Chemical Inhomogeneity and Microstructural Features during Postprocessing
Open Access
- 18 March 2024
- journal article
- research article
- Published by Wiley in Advanced Engineering Materials
- Vol. 26 (8) , 2301902
Abstract
Powder bed fusion‐laser beam/metal (PBF‐LB/M) additive manufacturing provides a high potential to overcome the poor machinability of nickel‐free high interstitial alloy austenitic (HIA) steels. Therefore, this study focuses on the PBF‐LB/M processability of HIA X40MnCrMoN21‐18‐2 and the effect of postprocessing on microstructure and chemical homogeneity. Samples are fabricated on a laboratory and industrial PBF‐LB/M machine and subsequently postprocessed by conventional solution annealing or hot isostatic pressing (HIP). The influence of the processing steps on the microstructure and on the chemical composition is evaluated by scanning electron microscopy, X‐ray diffraction, transmission electron microscopy, atom probe tomography, and electron backscatter diffraction. The commercially available HIA powder exerts good processability, both by optimized and predefined PBF‐LB/M parameters. Loss of Mn and N is detected after PBF‐LB/M processing. Chemical homogenization but no further change in composition occurs during postprocessing. The as‐built microstructure shows segregation of elements (N, Mo, Cr, Mn) in intercellular spaces. A thermodynamic calculation confirms that N approaches a para‐equilibrium state in the PBF‐LB/M as‐built condition, while C does not. Porosity can be reduced by thermomechanical posttreatment with HIP. At the same time, HIP partially recrystallizes the microstructure, while (Mn + Cr) 2 SiO 4 type oxides delay recovery and recrystallization of the microstructure.Keywords
Funding Information
- Mercator Research Center Ruhr (KO‐2021‐0025)
- Mercator Research Center Ruhr (KO‐2021‐0025)
This publication has 21 references indexed in Scilit:
- Interstitial strengthening in f.c.c. metals and alloysAdvanced Powder Materials, 2022
- Influences of powder morphology and spreading parameters on the powder bed topography uniformity in powder bed fusion metal additive manufacturingAdditive Manufacturing, 2021
- Microstructure and mechanical properties of 316L austenitic stainless steel processed by different SLM devicesThe International Journal of Advanced Manufacturing Technology, 2020
- Microstructure and properties of high-strength C + N austenitic stainless steel processed by laser powder bed fusionAdditive Manufacturing, 2020
- Study on microstructure and tensile properties of high nitrogen Cr-Mn steel processed by CMT wire and arc additive manufacturingMaterials & Design, 2019
- Formation of metastable cellular microstructures in selective laser melted alloysJournal of Alloys and Compounds, 2017
- Microstructure and Fracture Behavior of 316L Austenitic Stainless Steel Produced by Selective Laser MeltingJournal of Materials Science & Technology, 2016
- Recovery and Recrystallization: Phenomena, Physics, Models, Simulation2014
- Characterization of the surface of Fe–19Mn–18Cr–C–N during heat treatment in a high vacuum — An XPS studyMaterials Characterization, 2012
- Nonequilibrium grain-boundary cosegregation of nitrogen and chromium in NiCrMoV steelMetallurgical and Materials Transactions A, 2005