Optimization of Chitin Nanofiber Preparation by Ball Milling as Filler for Composite Resin
Open Access
- 6 July 2022
- journal article
- research article
- Published by MDPI AG in Journal of Composites Science
- Vol. 6 (7) , 197
Abstract
Chitin nanofiber is a nanomaterial produced by pulverizing chitin, the main component of crab shells. Since it has excellent mechanical properties, it is expected to be used as a reinforcing material to strengthen materials. Chitin was mechanically ground in water using a ball mill to prepare nanofibers. The ball size, total ball weight, and milling time were varied, and the resulting water dispersion and the cast film were analyzed to optimize the conditions for efficient preparation. The length and width of the nanofibers were also measured by SEM and AFM observations. The size of the balls affected the level of grinding and the intensity of impact energy on the chitin. The most efficient crushing was achieved when the diameter was 1 mm. The total ball weight directly affects the milling frequency, and milling proceeds as the total weight increases. However, if too many balls occupy the container, the grinding efficiency decreases. Therefore, a total ball weight of 300 g was optimal. Regarding the milling time, the chitin becomes finer depending on the increase of that time. However, after a specific time, the shape did not change much. Therefore, a milling time of approximately 150 min was appropriate.Keywords
This publication has 31 references indexed in Scilit:
- Preparation of Chitin Nanofibers from MushroomsMaterials, 2011
- Preparation and characterization of optically transparent chitin nanofiber/(meth)acrylic resin compositesGreen Chemistry, 2011
- Simple preparation method of chitin nanofibers with a uniform width of 10–20nm from prawn shell under neutral conditionsCarbohydrate Polymers, 2011
- Fibrillation of dried chitin into 10–20nm nanofibers by a simple grinding method under acidic conditionsCarbohydrate Polymers, 2010
- Acetylation of Chitin Nanofibers and their Transparent Nanocomposite FilmsBiomacromolecules, 2010
- Preparation of Chitin Nanofibers with a Uniform Width as α-Chitin from Crab ShellsBiomacromolecules, 2009
- Obtaining Cellulose Nanofibers with a Uniform Width of 15 nm from WoodBiomacromolecules, 2007
- Microstructure and crystallographic texture of the chitin–protein network in the biological composite material of the exoskeleton of the lobster Homarus americanusMaterials Science and Engineering: A, 2006
- Determination of the degree of deacetylation of chitin and chitosan by X-ray powder diffractionCarbohydrate Research, 2005
- Lateral thermal expansion of chitin crystalsJournal of Polymer Science Part B: Polymer Physics, 2000