Effect of Deep Cryogenic Time on Martensite Multi-Level Microstructures and Mechanical Properties in AISI M35 High-Speed Steel
Open Access
- 23 September 2022
- Vol. 15 (19) , 6618
Abstract
High-speed steel is widely used for cutting tools due to its convenience of preparation and cost-effectiveness. Previous research has shown that deep cryogenic treatments improve the mechanical properties of high-speed steel, due to the transformation of the residual austenite and the precipitation of carbide, while few studies have researched martensitic changes. The variations in martensite multi-level microstructures in AISI M35 high-speed steel, treated over different deep cryogenic time periods, were investigated in this study. Meanwhile, the effect of these variations on the mechanical properties of the selected steel was discussed. It was found that prolonging deep cryogenic time facilitated an increase in dislocation, low-angle grain boundary, and the coincident-site lattice boundary (especially the twin boundary) of martensite. The size of the martensite block (db) and lath (dl) decreased with deep cryogenic time. However, the effect on the microstructure was limited when the cryogenic treatment time exceeded 5 h. The increase in dislocation decreased the temperature for carbide precipitation and promoted fine carbide precipitation during tempering. The refinement of martensite multi-level microstructures and the greater precipitation of fine carbides gave the tempered specimens excellent impact toughness. The impact toughness of the tempered samples undergoing deep cryogenic treatment for more than 5 h was about 32% higher than the sample without deep cryogenic treatment.Keywords
Funding Information
- Liaoning Revitalization Talents Program (XLYC1902097, N172410006-1)
- Fundamental Research Funds for the Central Universities (XLYC1902097, N172410006-1)
This publication has 45 references indexed in Scilit:
- Study of tempering behavior of lath martensite using in situ neutron diffractionMaterials Characterization, 2015
- The effect of thermo-mechanical processing on grain boundary character distribution in Incoloy 800H/HTMaterials Science and Engineering: A, 2015
- Study on microstructure and mechanical characteristics of low-carbon steel and ferritic stainless steel jointsMaterials Science and Engineering: A, 2014
- Effects of heat treatment influencing factors on microstructure and mechanical properties of a low-carbon martensitic stainless bearing steelMaterials Science and Engineering: A, 2014
- Evolution of compressive strains in retained austenite during sub-zero Celsius martensite formation and temperingActa Materialia, 2014
- Experimental verification of segregation of carbon and precipitation of carbides due to deep cryogenic treatment for tool steel by internal friction methodMaterials Science and Engineering: A, 2013
- Effects of mischmetal addition on phase transformation and as-cast microstructure characteristics of M2 high-speed steelJournal of Rare Earths, 2013
- Effect of Substructure on Toughness of Lath Martensite/Bainite Mixed Structure in Low-Carbon SteelsJournal of Iron and Steel Research International, 2010
- Sub-zero treatments of AISI D2 steel: Part II. Wear behaviorMaterials Science and Engineering: A, 2010
- The effect of structure on the deformation of as-quenched and tempered martensite in an Fe-0.2 pct C alloyMetallurgical Transactions A, 1976