Platinum supported on titanium–ruthenium oxide is a remarkably stable electrocatayst for hydrogen fuel cell vehicles
- 23 December 2013
- journal article
- research article
- Published by National Academy of Sciences in Proceedings of the National Academy of Sciences
- Vol. 111 (1) , 45-50
Abstract
We report a unique and highly stable electrocatalyst—platinum (Pt) supported on titanium–ruthenium oxide (TRO)—for hydrogen fuel cell vehicles. The Pt/TRO electrocatalyst was exposed to stringent accelerated test protocols designed to induce degradation and failure mechanisms identical to those seen during extended normal operation of a fuel cell automobile—namely, support corrosion during vehicle startup and shutdown, and platinum dissolution during vehicle acceleration and deceleration. These experiments were performed both ex situ (on supports and catalysts deposited onto a glassy carbon rotating disk electrode) and in situ (in a membrane electrode assembly). The Pt/TRO was compared against a state-of-the-art benchmark catalyst—Pt supported on high surface-area carbon (Pt/HSAC). In ex situ tests, Pt/TRO lost only 18% of its initial oxygen reduction reaction mass activity and 3% of its oxygen reduction reaction-specific activity, whereas the corresponding losses for Pt/HSAC were 52% and 22%. In in situ-accelerated degradation tests performed on membrane electrode assemblies, the loss in cell voltage at 1 A · cm−2 at 100% RH was a negligible 15 mV for Pt/TRO, whereas the loss was too high to permit operation at 1 A · cm−2 for Pt/HSAC. We clearly show that electrocatalyst support corrosion induced during fuel cell startup and shutdown is a far more potent failure mode than platinum dissolution during fuel cell operation. Hence, we posit that the need for a highly stable support (such as TRO) is paramount. Finally, we demonstrate that the corrosion of carbon present in the gas diffusion layer of the fuel cell is only of minor concern.Keywords
This publication has 37 references indexed in Scilit:
- Highly Stable and CO-Tolerant Pt/Ti0.7W0.3O2 Electrocatalyst for Proton-Exchange Membrane Fuel CellsJournal of the American Chemical Society, 2010
- Electrocatalytic activity and stability of niobium-doped titanium oxide supported platinum catalyst for polymer electrolyte membrane fuel cellsApplied Catalysis B: Environment and Energy, 2010
- Impact of carbon monoxide on PEFC catalyst carbon support degradation under current-cycled operating conditionsElectrochimica Acta, 2009
- Controlling the Density of Amine Sites on Silica Surfaces Using Benzyl SpacersLangmuir, 2006
- Electrooxidation of methanol on Pt microparticles dispersed on SnO2 thin filmsElectrochimica Acta, 2004
- Sub-stoichiometric titanium oxides as ceramic electrodes for oxygen evolution—structural aspects of the voltammetric behaviour of TinO2n−1Electrochimica Acta, 1994
- The influence of Pt on the electrooxidation behaviour of carbon in phosphoric acidElectrochimica Acta, 1992
- Activity‐Composition Relationships of the Solid Solution (Ti,Mo)O 2 in the Temperature Range 1350 to 1600 KJournal of the American Ceramic Society, 1986
- An Investigation of the Electrochemistry of a Series of Metal Dioxides with Rutile‐Type Structure: MoO2, WO 2, ReO2, RuO2, OsO2, and IrO2Journal of the Electrochemical Society, 1977
- Melting Relation in the System TiO 2 ‐WO 2Journal of the American Ceramic Society, 1968