An Experimental Study on the Dynamic Response of a Beam Structure Containing a Pseudo Joint
Authors:
- 1 September 1994
- journal article
- review article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science
- Vol. 208 (5) , 321-328
Abstract
The effects of frictional damping on the dynamic response of a beam structure have been investigated. The frictional damping was contributed from the slip mechanisms in a ‘pseudo’ joint, that is a joint that did not take any static load. Using pseudo joints for vibration control has significant advantages over using joints that are designed both to take static load and to introduce frictional damping; because there is almost no restriction on the configuration of the pseudo joint, the undesirable side effects related to the frictional damping such as fretting corrosion of contact surfaces and loss of static stiffness are zero if the frictional damping from a pseudo joint is utilized. An ‘optimum’ clamping force was found which minimized the magnitude of the frequency response function (FRF) of the structure under excitation. A reduction of about 20 dB in the amplitudes of the FRFs was achieved by adjusting the clamping force at the joint. Frictional damping was found to be significant over the measured frequency range of 20-2000 Hz, and it was particularly effective over the range of 20-1000 Hz. The magnitudes of the FRFs of the structure were determined by the ratio of clamping force to excitation force. They were insensitive to the change of clamping force near its optimum value; also the optimum clamping force was not sensitive to small modifications to the structure. Therefore, utilizing frictional damping in pseudo joints is an effective technique for vibration control.Keywords
This publication has 9 references indexed in Scilit:
- A New Receptance-Based Perturbative Multi-Harmonic Balance Method for the Calculation of the Steady State Response of Non-Linear SystemsJournal of Sound and Vibration, 1994
- Two Condensation Algorithms for the Receptance-Based Perturbative Multi-Harmonic Balance MethodJournal of Sound and Vibration, 1994
- An Alternating Frequency/Time Domain Method for Calculating the Steady-State Response of Nonlinear Dynamic SystemsJournal of Applied Mechanics, 1989
- The influence of microslip on vibratory response, part I: A new microslip modelJournal of Sound and Vibration, 1986
- The Control of Structural Vibration by Frictional Damping in Electro-Discharge Machined JointsJournal of Mechanical Design, 1980
- The damping of plate vibration by interfacial slip between layersInternational Journal of Machine Tool Design and Research, 1978
- The damping of structural vibration by rotational slip in jointsJournal of Sound and Vibration, 1977
- Some effects of interface preparation on frictional damping in jointsInternational Journal of Machine Tool Design and Research, 1975
- Frictional damping applied to a cantilever-beam structure: A theoretical and experimental response comparisonInternational Journal of Machine Tool Design and Research, 1974