Investigation of Turbulent Skin Friction Behaviour over Coated, Biofouled, and Laser-Cleaned Marine Surfaces
Open Access
- 31 August 2026
- journal article
- research article
- Published by MDPI AG in Journal of Marine Science and Engineering
- Vol. 14 (17) , 1599
Abstract
This study investigates the turbulent skin friction behaviour of original coated, slime/algae-covered, and laser-cleaned marine surfaces through a combined experimental and numerical approach under fully developed channel flow conditions. Numerical validation was performed against established smooth-wall experimental datasets over the investigated Reynolds number range using Reynolds-Averaged Navier–Stokes (RANS) and Large-Eddy Simulation (LES) approaches. LES provided the closest agreement with the reference data, while the two-dimensional wall function RANS - SST model was selected for subsequent rough-wall simulations based on its balance between predictive accuracy and computational cost. The selected RANS approach was independently validated against rough-wall experimental data, showing good agreement in predicted skin friction behaviour. Measured surface elevation data were used to estimate equivalent sand grain roughness for the original coated, slime/algae-covered, and post-cleaning surfaces. The post-cleaning surfaces exhibited lower measured roughness and predicted skin friction coefficients than the slime/algae-covered surfaces, while the three investigated laser configurations produced broadly similar roughness characteristics and hydrodynamic responses. However, the original coating was characterised before immersion, whereas the fouled and post-cleaning surfaces had undergone water exposure. Because the coating is hydrolysing/self-polishing, the observed post-cleaning roughness reduction may be partly or entirely associated with immersion-induced coating changes and cannot be attributed uniquely to laser treatment. The results therefore demonstrate an association between the post-cleaning surface condition and reduced roughness and predicted skin friction, but do not establish a causal relationship between laser treatment and these reductions.
Keywords
Funding Information
- Department for Transport (10160835)
- Clean Maritime Demonstration Competition
- Engineering and Physical Sciences Research Council (EP/X035751/1)
This publication has 44 references indexed in Scilit:
- Protected detached eddy simulation: A model for advanced shielding function performanceAerospace Science and Technology, 2025
- An experimental study on determining the best operating condition of an automated underwater biofouling cleaning toolApplied Ocean Research, 2024
- Assessment of aerodynamic roughness parameters of turbulent boundary layers over barnacle-covered surfacesExperiments in Fluids, 2023
- Effects of boundary layer thickness on the estimation of equivalent sandgrain roughness in zero-pressure-gradient boundary layersExperiments in Fluids, 2022
- Assessment of Reynolds-stress models for aeronautical applicationsInternational Journal of Heat and Fluid Flow, 2022
- A novel tool for cost and emission reduction related to ship underwater hull maintenanceJournal of Cleaner Production, 2022
- Multi-objective optimization of ship hull modification based on resistance and wake field improvement: combination of adjoint solver and CAD-CFD-based approachJournal of the Brazilian Society of Mechanical Sciences and Engineering, 2021
- Skin-friction behavior in the transitionally-rough regimeInternational Journal of Heat and Fluid Flow, 2016
- Progress in DES for wall-modelled LES of complex internal flowsComputers & Fluids, 2012
- A hybrid RANS-LES approach with delayed-DES and wall-modelled LES capabilitiesInternational Journal of Heat and Fluid Flow, 2008