Prediction of the sliding type and critical factor of safety in homogeneous finite slopes
Open Access
- 23 September 2019
- journal article
- research article
- Published by Springer Nature in Applied Water Science
- Vol. 9 (7) , 158
Abstract
In this paper, the effect of soil material parameters including soil specific weight (γ), cohesion (C), angle of internal friction ( $$\emptyset$$ ), and geometric parameter of slope including angle with the horizontal (β) for a constant slope height (H) on factor of safety (Fs) was investigated.Fswas considered in two scenarios: (1) slope with dry condition, and (2) with steady-state saturated condition that comprises water level drawdown circumstances. In addition, the type of slip circle was also investigated. For this purpose, theSLOPE/Wsoftware as a subgroup ofGeo-Studiosoftware was implemented. Results showed that decreasing of water table level and omitting the hydrostatic pressure on the slope consequently would result in safety factor decrement. Comparison of the plane and circular failure surfaces showed that plane failure method produced good results for near-vertical slopes only. Determination of slip type showed that for state (30° < β < 45°), the three types of failure circles (toe, slope or midpoint circle) may occur. For state (45° < β < 60°), two modes of failure may occur: midpoint circle and toe circle. For state (β > 60°), the mode of failure circle is only toe circle. Linear and nonlinear regression equations were obtained for estimation of slope safety factor.
Keywords
This publication has 11 references indexed in Scilit:
- The prediction of the critical factor of safety of homogeneous finite slopes using neural networks and multiple regressionsComputers & Geosciences, 2013
- Taylor’s Slope Stability Charts RevisitedInternational Journal of Geomechanics, 2011
- Stability Charts for Uniform SlopesJournal of Geotechnical and Geoenvironmental Engineering, 2002
- Stability analysis of embankments and slopesGéotechnique, 1973
- Shear Strength and Stability of Man-Made SlopesJournal of the Soil Mechanics and Foundations Division, 1970
- A Method of analysis of the Stability of Embankments Assuming Parallel Inter-Slice ForcesGéotechnique, 1967
- The Analysis of the Stability of General Slip SurfacesGéotechnique, 1965
- Stability Charts for Earth Slopes During Rapid DrawdownGéotechnique, 1963
- Stability Coefficients for Earth SlopesGéotechnique, 1960
- The use of the Slip Circle in the Stability Analysis of SlopesGéotechnique, 1955