Reversible Color Changes in Lamella Hybrids of Poly(diacetylenecarboxylates) Incorporated in Layered Double Hydroxide Nanosheets
- 8 February 2005
- journal article
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry B
- Vol. 109 (8) , 3199-3206
Abstract
The present study is an investigation of a reversible thermal color change induced in lamella hybrids of poly(diacetylenecarboxylates) incorporated in layered double hydroxide (LDH) nanosheets. These poly-[m,n]/LDH hybrids prepared by the photo- or gamma-ray-induced polymerization of diacetylenecarboxylates, i.e., CH(3)(CH(2))(m)()(-)(1)CC-CC(CH(2))(n)()(-)(1)CO(2)(-) (mono-[m,n]), and intercalated in LDH lamella sheets, were observed to develop colors ranging from yellow to blue. The change in color was found to depend greatly on the alkyl carbon numbers of the mono-[m,n] (m,n = 10,11; 5,11; 10,5; 16,1) values. Moreover, the conformational alignment of the mono-[m,n] within the LDH was observed to be a crucial factor in color development, which was greatly affected by the intercalation degrees and extent of poly(ene-yne) linkage elongation of the polymers. For the poly-[m,n]/LDH hybrids investigated, a reversible color change was found to occur repeatedly and remarkably for the poly-[10,11]/LDH hybrid. This color change occurred at temperatures between ca. 20 and 80 degrees C back and forth from purple red to bright orange, in stark contrast to the irreversible color change for poly-[10,11] without LDH. Moreover, DSC and Raman spectroscopic studies of the LDH hybrids showed that the thermochromic temperature corresponded to the phase transition temperature of 80 degrees C. XRD analysis also indicated that the poly-[m,n]/LDH hybrid could retain its lamella structure during such thermochromic color changes, enabling conformational recovery in the polymer chains by a cooling down of the hybrids to temperatures lower than the transition temperature, while the nonhybrid poly-[10,11] powders exhibited an irreversible color change at 60 degrees C, above which the polymer powder turned amorphous.Keywords
This publication has 29 references indexed in Scilit:
- The Self-Assembling Properties of Stearate Ions in Hydrotalcite Clay CompositesLangmuir, 2003
- Diacetylene polymerization in self-assembled monolayers: influence of the odd/even nature of the methylene spacerPolymer, 2000
- Novel polydiacetylenes for optical materials: beyond the conventional polydiacetylenesJournal of Materials Chemistry, 2000
- Molecular Architecture of Regularly Mixed π-Conjugated Systems Using Diacetylene Solid-State PolymerizationMolecular Crystals and Liquid Crystals, 1998
- Infrared and Resonance Raman Spectroscopic Study on the Photopolymerization Process of the Langmuir−Blodgett Films of a Diacetylene Monocarboxylic Acid, 10,12-Pentacosadiynoic AcidLangmuir, 1996
- Intercalation in hydrotalcite-like layered Zn/Al-double hydroxides with naphthalenedisulphonatesJournal of Materials Science, 1995
- A General Method for the Synthesis of Diacetylenic AcidsSynthetic Communications, 1986
- Polymerization of Tricosa‐10,12‐diynoic Acid in MultilayersAngewandte Chemie International Edition, 1976
- Resonance Raman study of the thermochromic phase transition of a polydiacetyleneJournal of the American Chemical Society, 1976
- A New Reaction of 1-Iodoacetylenes and Some New Mercury AcetylidesJournal of the American Chemical Society, 1933