Effect of fiber size on structural and tensile properties of electrospun polyvinylidene fluoride fibers
- 18 October 2014
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 55 (8) , 1812-1817
Abstract
We use electrospinning to obtain polyvinylidene fluoride (PVDF) fibers and demonstrate simultaneous improvements in β‐crystal microstructure and in tensile properties of fibers with reduction of their diameter. PVDF fibers with average diameters ranging from 70 to 400 nm are obtained by controlling the concentration of the polymer in the electrospinning solution. The amount of β‐crystals present is found to be greater for finer diameter fibers, yielding a maximum β‐phase fraction of 0.86 in the 70‐nm fibers. Moreover, the deformation behavior of the fibers reveals that the tensile modulus and strength improve with reductions in fiber size. Sharp increases in tensile properties are demonstrated when the size of the fibers is reduced below 175 nm. We attribute the enhanced concentration of β‐crystals and the tensile behavior of finer diameter fibers to the extensional forces experienced by the material during electrospinning. POLYM. ENG. SCI., 55:1812–1817, 2015. © 2014 Society of Plastics EngineersKeywords
Funding Information
- US National Science Foundation (CAREER Award CMMI 0746703 and Award DMI 0520967 (to S.C.W.))
This publication has 36 references indexed in Scilit:
- Microstructure development in electrospun carbon nanotube reinforced polyvinylidene fluoride fibers and its influence on tensile strength and dielectric permittivityComposites Science and Technology, 2013
- Enhanced Piezoelectric Properties of Electrospun Poly(vinylidene fluoride)/Multiwalled Carbon Nanotube Composites Due to High β-Phase Formation in Poly(vinylidene fluoride)The Journal of Physical Chemistry C, 2013
- Piezoelectric properties of PVDF/MWCNT nanofiber using near-field electrospinningSensors and Actuators A: Physical, 2013
- Piezoelectric β-polymorph formation and properties enhancement in graphene oxide – PVDF nanocomposite filmsApplied Surface Science, 2012
- Nanocomposite films of poly(vinylidene fluoride) filled with polyvinylpyrrolidone‐coated multiwalled carbon nanotubes: Enhancement of β‐polymorph formation and tensile propertiesPolymer Engineering & Science, 2012
- Improved Tensile Strength and Ferroelectric Phase Content of Self‐Assembled Polyvinylidene Fluoride Fiber YarnsMacromolecular Materials and Engineering, 2011
- Nanoscale investigation of ferroelectric properties in electrospun barium titanate/polyvinylidene fluoride composite fibers using piezoresponse force microscopyComposites Science and Technology, 2011
- Electrospinning induced ferroelectricity in poly(vinylidene fluoride) fibersNanoscale, 2011
- A flexible piezoelectric force sensor based on PVDF fabricsSmart Materials and Structures, 2011
- Comparison of Piezoelectric Energy Harvesting Devices for Recharging BatteriesJournal of Intelligent Material Systems and Structures, 2005